Loading ...
Loading ...
Loading ...
14
Replacing the Oven Light
WARNING
• Before starting, ensure all range surfaces are cool enough to touch.
• Do not use the oven without the lens in place; the lens protects
the bulb from breakage due to high temperature and mechanical
shock.
• Replacing the lens without aligning the cutout with the light
socket will damage the light fixture.
• Do not remove the lens with a screwdriver, which is much more
likely than a table knife to cause damage.
• Replace the spent bulb with Dacor Part No. 108774 only; call Dacor
Customer assurance to order the bulb; see the inside front cover for
contact information).
The owner shall change the bulb. If the light does not work, check
Troubleshooting (Pg. 16) before replacing it.
IMPORTANT: Do not touch the new bulb with bare fingers.
Halogen bulbs are sensitive to hand oils, which can shorten their
lifespan.
1. Unplug the range, and remove the racks and rack support.
2. Supporting the lens with one hand, gently loosen it with a
table knife, and pull it
straight out.
3. Pull the old bulb straight
out of the socket.
4. Wearing a glove, insert a
new bulb in the socket.
5. Align the cutout on the
lens’ inside rim with the
light socket, and gently
press the lens into place.
6. Replace the rack support
and racks, and plug in the
range.
Care and Cleaning
2. Soak the filter in hot, soapy water, then rinse, and dry it fully.
3. With the mounting clips (open-end down) facing the rear wall,
push the filter down, hooking the clips onto the horizontal bar.
Cleaning Stainless-Steel Surfaces
CAUTION
To avoid damage, always wipe stainless-steel “with” the grain.
• Clean the range’s stainless-steel cladding with Dacor Stainless
Steel Cleaner. (Contact Dacor Customer Assurance to reorder.)
• Rinse and dry with a soft, lint-free cloth.
• Apply a small amount of baby oil to restore lustre.
Cleaning Brass/Chrome/Copper Surfaces
Clean these surfaces as you would stainless steel. (See Cleaning
Stainless-Steel Surfaces.)
Cleaning the Door Glass
• Clean the glass with a solution of mild detergent and hot water.
• Remove prints/smears with a mild glass cleaner.
• Dry fully with a soft, lint-free cloth.
Cleaning the Broil Burner
WARNING
To avoid damaging the broil burner, do not scrub it or its igniter, or
spray them with cleaner.
The broil burner is self-cleaning. To burn off grime, close the oven
door, set the oven to BROIL for 10 minutes, then turn the oven off.
Clips on back
of filter
Horizontal
edge
Push up to
remove
Light
fixture
Light
socket
Lens
Lens cutout
Bulb
Loading ...
Loading ...
Loading ...