Loading ...
Loading ...
Loading ...
Troubleshooting en
37
Fault Cause and troubleshooting
The length of the pro-
gramme changes dur-
ing the drying cycle.
The programme operation is optimised electronically.
This may change the programme duration.
▶
Not a fault – no action required.
Pumping noise. Condensation pump active.
▶
Not a fault – normal operating noise.
Buzzing noise. Compressor ventilation active.
▶
Not a fault – normal operating noise.
The drying time is too
long.
Fluff filter is soiled.
▶
→"Cleaning the fluff filter", Page28
The ambient temperature is greater than 30 °C.
▶
Ensure that the ambient temperature is lower than
30 °C.
The ambient temperature is lower than 15 °C.
▶
Ensure that the ambient temperature is above 15
°C.
Insufficient air circulation at the appliance's installation
location.
▶
Ventilate the appliance's installation location.
Appliance air inlet is blocked.
▶
Ensure that the air inlet on the appliance is kept
clear.
Heat exchanger is soiled.
1.
→"Opening the base unit", Page32.
2. Clean the heat exchanger.
→"Cleaning the base unit", Page32
3.
→"Closing the base unit", Page33.
Water is leaking from
the appliance.
Appliance is not correctly aligned.
▶
Aligning the appliance
Water drain hose is not connected correctly.
▶
Ensure that the water drain hose is connected cor-
rectly.
→"Connecting the water drain hose", Page14
The laundry is too
damp.
Unsuitable programme for the type of fabric.
▶
Set a timed programme for the subsequent drying.
→"Programmes", Page24
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The load is too large.
Loading ...
Loading ...
Loading ...