Loading ...
Loading ...
Loading ...
TO REPLACE BELT
1, Install new
belt over motor
drive, then %'
over brush
sprocket,
NOTE: See _/O_____is_k i_ _
PARTS AND e
FEATURES for
belt number,,
2, Place agitator
assembly back into
Power-Mate ®_
3, Reinstall
agitator cover
by lining up
the front tabs
and slots and
rotating
downward
until the
latches snap
into place_
Agitator Cover
4o Line up
front of
cover and
baser Rest
cover on
front edge of
base as
shown.
Cover Base
'_ _1 , , _ II _T_ _
I[ _ , _ Top View
5. NOTE: On dirt
sensor models
be sure that the
board is upright
and the wires are
tucked back as
shown.
6, Rotate cover
back,. Press cover
firmly until side
and rear tabs snap
into place, Turn
Power-Mate ®
upside down and
replace two (2)
cover screws,
t. Remove Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section_
Push In
And Turn
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove.
And Turn
k._3o Push in and turn
bulb clockwise, to
replace,1 Bulb must
not be higher than
15 Watts(130 Volts).
18
4. Reinstall Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR CLEAN*
ING section.
NOTE: See PARTS AND FEATURES for
bulb number.
Loading ...
Loading ...
Loading ...