Loading ...
Loading ...
Loading ...
12
Installation instructions
11
Attach double sided foam to the back
of the water filter head as shown in
Diagram5. Write the date to be replaced
on the filter (date installed +6months).
Remove the double sided foam backing
and attach the filter to the desired
position, reinforcing the filter with the
screws provided as located in step 10
(refer to the previous page).
12
Run the ¼” (6 mm) tubing to the back of
the refrigerator ensuring there is enough
tubing to pull the refrigerator out for
service.
13
Using the measurement guide located on
the rear compartment cover as shown in
Diagram 6. Mark out ⁄”(16 mm), on the
end of the tubing as shown in Diagram 7.
14
Insert the tubing marked ⁄” (16 mm)
into the water (solenoid) valve up to the
marked line as shown in Diagram 8.
15
Pull gently on tubing to ensure it is locked
in as shown in Diagram 9.
16
The completed installation should look
like Diagram11 on page 13.
17
Turn the isolating faucet on and check
that all connections are dry and free of
drips.
18
Coil water line tubing behind the
refrigerator. Pushyour refrigerator into
place being careful notto kink or squash
the water line tube running into the water
(solenoid) valve.
19
Read pages 13 – 14 carefully and then
turn refrigeratoron.
Diagram 5
Fig.7 Double sided
foam attachment
US
CA
Fig.8 Waterline connection to refrigerator
Diagram 9
Diagram 6
Diagram 7
Diagram 8
Loading ...
Loading ...
Loading ...