Loading ...
Loading ...
Loading ...
7
to adequately clean the coffeemaker. When
the cycle is completed and the ve beeps
sound, the coffeemaker will shut off. Turn the
coffeemaker on to see if the self clean light
continues to ash. If it does, turn it off and
then repeat the cleaning procedure with a
fresh solution of vinegar and water.
If the self clean light no longer ashes, turn
the coffeemaker off and then run one cycle
of fresh cold water through the unit before
using the unit again to brew coffee.
Notes on the Self Clean Function
Pressing the Self Clean button cancels all
other settings. If it is pressed accidentally,
press it again to return the coffeemaker to
all its previous settings. Pressing On/Off will
also exit the self clean mode and turn the
coffeemaker off.
1-4 Cup Setting
The 1-4 cup setting button is used when
you make small amounts of coffee. Normal
coffeemakers will produce a colder batch
of coffee when smaller amounts are made,
because the heater doesn’t have enough
time to properly warm up to heat a small
amount.
The 1-4 setting basically double heats the
water, making your smaller amount as piping
hot as a full pot would be.
To use: When making a smaller amount,
press the 1-4 button on the control panel
after turning on the unit.
Heater Plate ‘Keep Warm’ Control
The knob on the right of the control panel
is the heater plate control setting for after
brewing temperature. You can choose one of
three heat settings to keep your coffee warm:
low, medium, or high.
MAKING COFFEE
Before you make the rst pot of coffee
in your new Cuisinart
®
Brew Central
®
Coffeemaker, we recommend operating
the coffeemaker once using only water and
a paper lter. This will remove any dust or
residues that remain in the system from the
manufacturing process.
1. Insert the Water Filter
a. Remove the lter from polybag and soak
in cold tap water for 15 minutes.
b. Remove the water lter holder from
the coffeemaker by lifting it out of the
reservoir area with your thumb and
fore nger.
c. Grasp stem in one hand. Using thumb
of other hand, gently press down and
pull toward you. Compartment will ip
open.
d. Place the lter in the holder and close
the water lter holder; you will hear a
snap indicating it is in place.
NOTE: Caution must be used when inserting
the charcoal lter. Improper placement in the
holder can cause tearing of the lter skin.
e. Hold the lter under cold running tap
water for 10 seconds to ush. You
should place the hole openings in the
side of the unit directly under the water
stream.
f. Allow the lter to drain completely.
g. Replace the water lter holder in the
reservoir area of the coffeemaker,
pushing it all the way down to the base
of the unit, along the reservoir wall.
NOTE: We recommend changing the water
lter every 60 days or 60 uses, more often if
you have hard water.
Loading ...
Loading ...
Loading ...