Loading ...
Loading ...
Loading ...
10. Move throttle lever to "Fast" position, shown here
as a rabbit.
Fast
Stop
J
Throttle
Lever in
_'_ STOP
position
NOTE: For a warm engine, be sure the throttle lever is
in the "Fast" position.
To start the engine for the very first time:
11. Make sure throttle lever is in "Fast" position
(indicated on the engine as a rabbit).
12. Push primer bulb firmly 5 times, waiting 2 seconds
between each push.
To start engine thereafter:
11. Make sure throttle lever is in "Fast" position
(indicated on the engine as a rabbit).
12. Press primer bulb firmly 3 times, waiting
2 seconds between each push. For a warm
engine, DO NOT press primer bulb.
13. When starting engine, position yourself as
recommended below. Grasp handle and pull recoil
starter lightly until you feel some resistance, then
pull briskly.
WARNING
ALWAYS point gun in safe direction and squeeze spray
gun trigger, to release pressure and avoid kickback each
time, before starting engine.
When starting engine, pull cord slowly until resistance is
felt and then pull rapidly to avoid kickback.
After each starting attempt, where engine fails to run,
always point gun in safe direction and squeeze spray
gun trigger to release high pressure.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when gun kicks back.
14. Return starter grip handle slowly. DO NOT let rope
"snap back" against starter.
NOTE: Always keep the throttle lever in the "Fast"
3osition when operating the pressure washer.
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment to cool before touching.
Keep at least 5 ft. (152 cm) clearance on all sides of
pressure washer including overhead.
Code of Federal Regulation (CFR) Title 36 Parks,
Forests, and Public Property require equipment powered
by an internal combustion engine to have a spark
arrester, maintained in effective working order, complying
to USDA Forest service standard 5100-1C or later
revision. In the State of California a spark arrester is
required under section 4442 of the California Public
resources code. Other states may have similar laws.
CAUTION
DO NOT move pressure washer while running.
Always use handle to lift equipment.
NEVER pull on hoses to move equipment.
Loading ...
Loading ...
Loading ...