Loading ...
Loading ...
Loading ...
NOTE: If engine dies with the choke
lever at the OFF CHOKE position, move
the choke lever to HALF CHOKE and
pull the rope until the engine runs.
9. To stop engine, move switch to OFF.
STARTING A WARM ENGINE
1. Make sure switch is in ON position.
2. Move the choke lever to HALF
CHOKE.
3. Engage the throttle lock as directed
in STARTING A COLD ENGINE. Keep
the throttle lock engaged until the
engine runs smoothly.
4. Pull starter rope sharply until engine
runs, but no more than 5 pulls.
5. Allow the engine to run 10 seconds,
then move the choke lever to OFF
CHOKE. Release the throttle lock by
squeezing and releasing the trigger.
NOTE: If engine has not started, pull
starter rope 5 more pulls. If engine still
does not run, it is probably flooded.
Proceed to STARTING A FLOODED EN-
GINE.
STARTING A FLOODED ENGINE
Flooded engines can be started by
placing the switch in the ON position
and the choke lever in the OFF CHOKE
position; then, pull the rope to clear the
engine of excess fuel.
Starting could require pulling the starter
rope many times depending on how
badly the unit is flooded. Ifthe unit still
doesn't start, refer to the TROUBLE-
SHOOTING TABLE or call
1-800-235-5878.
WARNING: Disconnect the spark plug before performing maintenance
except for carburetor adjustments.
CUSTOMER RESPONSIBILITIES
CARE & MAINTENANCE TASK
Check for loose fasteners and parts
Check for damaged or worn parts
Inspect and clean unit and labels
Clean air filter
Replace spark plug
Replace fuel filter
GENERAL RECOMMENDATIONS
The warranty on this unit does not cov-
er items that have been subjected to
operator abuse or negligence. To re-
ceive full value from the warranty, the
operator must maintain unit as instruct-
ed in this manual. Various adjustments
will need to be made periodically to
properly maintain your unit.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Spark Plug Boot
• Air Filter
• Housing Screws
WHEN TO PERFORM
Before each use
Before each use
After each use
Every 5 hours of operation
Yearly
Yearly
sure engine stops; then restart engine
and continue.
• Fuel Tank - Do not use unit if fuel tank
shows signs of damage or leaks.
INSPECT AND CLEAN UNIT AND
LABELS
• After each use, inspect complete unit
for loose or damaged parts. Clean
the unit and labels using a damp
cloth with a mild detergent.
• Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
CHECK FOR DAMAGED OR
WORN PARTS
Refer replacement of damaged/worn
parts to your Sears Service Center.
• ON/OFF Switch - Ensure ON/OFF
switch functions properly by moving
the switch to the OFF position. Make
Air Filter Cover
Air
Filter
jJ
Screws
Loading ...
Loading ...
Loading ...