Loading ...
Loading ...
Loading ...
OPERRATINGPOSITION
&_'_ .... Eye
Protection
STOPPINGYOURENGINE
• Tostopengine,moveswitchtoOFR
BEFORESTARTINGTHEENGINE
• Fuelengine.Moveatleast10feet(3
meters)awayfromthefuelingsite.
• Holdtheunitonthegroundinthe
startingpositionasshown.Support
unitsothebladeisoffoftheground
andawayfromtrees,bushes,on-
lookers,etc.
STARTINGA COLD ENGINE (or a
warm engine after running out of
fuel)
Throttle Lock
f Throttle
k/ Lock-out
Throttle
Trigger
1. Engage the throttle lock as follows:
• press the throttle lock-out
• squeeze and hold throttle trigger
• press and hold throttle lock
• release the throttle trigger
Keep the throttle lock engaged until the
engine runs smoothly.
2. Make sure switch is in ON position.
ON OFF
...... Switch
3. Slowly press the primer bulb 6
times.
4. Move the choke lever to FULL
CHOKE.
Choke
Primer Bulb
5. Pull starter rope handle sharply 6
times.
NOTE: The engine may sound as if it is
trying to start before 6th pull. If so, go
to the next step immediately.
6 Move the choke lever to HALF
CHOKE.
7 Pull starter rope sharply until the en-
gine runs, but no more than 6 pulls.
NOTE: If the engine has not started af-
ter 6 pulls (at HALF CHOKE), check to
make sure the ON/OFF switch and the
choke lever are in the proper positions.
Then, move the choke lever to the
FULL CHOKE position and press the
primer bulb 6 times; pull the starter
rope 2 more times. Move the choke le-
ver to HALF CHOKE and pull the starter
rope until the engine runs, but no more
than 6 more pulls.
NOTE: If engine still has not started, it
is probably flooded. Proceed to START-
ING A FLOODED ENGINE.
8. Allow the engine to run 10 seconds,
then move the choke lever to OFF
CHOKE. Allow the unit to run for 30
more seconds at OFF CHOKE, then
release the throttle lock by squeez-
ing and releasing the trigger.
-6-
Loading ...
Loading ...
Loading ...