Loading ...
Loading ...
Loading ...
page 7
7. Canopy Assembly.
8. Blade Assembly.
Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed, and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded part of
slotted holes in canopy cover with screw heads in
bottom of canopy. Turn cover to the right (clockwise)
until it stops.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Slide blade through
one of the narrow, rectangular openings on
motor housing, aligning holes in blade with
holes in blade arm (located on the topside of
the motor housing)--refer to drawing at right.
Insert 3 blade attachment screws (along with
washers) and tighten screws securely with a
Phillips screwdriver. Repeat procedure for each
remaining blade.
Note: Tighten blade arm screws twice a year.
hanging bracket
screw
canopy
screw
canopy cover
blade
motor housing
blade attachment
screws and washers
blade arm
Loading ...
Loading ...
Loading ...