Loading ...
Loading ...
Loading ...
Installingthe BaggerAssembly
To install the bagger mounting bracket, follow these steps:
1. Remove, and discard, the four self-tap bolts on the rear frame
of the tractor, as shown in Fig. 3.
/
/
/
2'
/
/
/
/
Figure 3
5_
Figure 5
Attach the bagger hood over the grass-bag mounting
assembly as shown in Figure 6. Align the tabs on the hood
into the slots on the grass-bag mounting assembly. Secure the
bagger hood using two flange lock nuts (712-04150) included
in the same hardware pack.
2_
Install the bagger mounting bracket on the tractor, using four
710-3015 hex bolts from Hardware Pack 689-00210. See Fig. 4.
Feed each hex bolt through the tractor frame, the rear hood
mounting tube, and thread into the weld-nut on the bagger
mounting bracket, as shown in Fig. 4.
//
Figure 4
3. Install the grass-bag mounting assembly onto the bagger
mounting bracket by lowering it down (1) and fitting the
assembly into the slot provided in the mounting bracket. See
the Inset in Fig. 5.
4. Secure the grass-bag mounting assembly to the bagger
mounting bracket using the attachment knob (720-04061)
found in the hardware pack (689-00210). See (2)in Fig. 5.
Figure 6
6. Insert the chute tube through the grass-catcher hood, in the
opening provided. It is easiest to feed the end of the tube into
the opening with the chute tube flipped upside down, then
rotating right-side once inserted into the hood. See Fig. 7.
7. Install the bags onto the mounting frame as shown in Fig. 12
in the Operation section. Simply place the leading edge of the
bag onto the front frame rail, then rock the bag backwards and
down into place.
8. Repeatforthesecond bag.
8
Loading ...
Loading ...
Loading ...