Loading ...
Loading ...
Loading ...
16
Control Panel and Doors
Avoid using any abrasive cleaners including cream cleaners.
For best results, use a liquid detergent.
The same cleaner can be used on the doors, or alternatively,
using a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance.
After cleaning, polish with a dry cloth.
Removing the Glass Fronted Door Panels
n
DO NOT use harsh abrasive cleaners or sharp metal
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of
the glass.
Open the oven door fully and place the supplied holding pins
in the drop down hinges (Fig. 5.5).
Remove the top 2 xing screws using the Allen key supplied
and the door top strip (Fig. 5.6). Then lift the 2 glass panels
out.
To ret the door glass correctly, make sure that the printed
circle and square on the glass, match up to the pressed
holes of the same shape (Fig. 5.7). This will ensure the heat
reective side is in the correct position, facing towards the
oven.
Make sure that the rubber strips are all attached.
After cleaning, carefully ret the door panel. Push down
gently to release the holding pins and remove them.
Removing the Left-hand Main Oven Linings
Some of the lining panels can be removed for cleaning. You
will need to remove the shelves before removing the panels.
To remove the oven shelf supports lift until clear of the two
top supporting holes, and the middle xing screw and pull
outwards (Fig. 5.8).
To remove the side panels, take out the 5 xing screws on
each side, lift the panel and slide forwards.
To replace the liner, the cut-out section must be at the top of
the liner. Slide the liner towards the back of the oven cavity.
When this is in position you can replace the xing screws
and then the shelf supports. To do this, insert the top of the
support into the cut-out section, relocating the support
under the lower xing screw to secure into place.
Top strip
Rubber strip
Fig. 5.5
Fig. 5.6
Fig. 5.7
Fig. 5.8
Loading ...
Loading ...
Loading ...