Loading ...
Loading ...
Loading ...
Problem Possible cause Solution
The room temperature is too
high.
Refer to the "Installation" chap-
ter.
Food products placed in the
appliance were too warm.
Allow food products to cool to
room temperature before stor-
ing.
The door is not closed correct-
ly.
Refer to the "Closing the door"
section.
Door is misaligned or interferes
with ventilation grill.
The appliance is not levelled. Refer to the installation in-
structions.
Door does not open easily. You attempted to re-open the
door immediately after closing.
Wait a few seconds between
closing and re-opening of the
door.
The lamp does not work. The lamp is in stand-by mode. Close and open the door.
The lamp is defective. Contact the nearest Author-
ized Service Centre.
There is too much frost and
ice.
The door is not closed correct-
ly.
Refer to the "Closing the door"
section.
The gasket is deformed or
dirty.
Refer to the "Closing the door"
section.
Food products are not wrap-
ped properly.
Wrap the food products better.
Temperature is set incorrectly. Refer to the "Operation" chap-
ter.
Appliance is fully loaded and is
set to the lowest temperature.
Set a higher temperature. Re-
fer to the "Operation" chapter.
Temperature set in the appli-
ance is too low and the ambi-
ent temperature is too high.
Set a higher temperature. Re-
fer to the "Operation" chapter.
Water flows on the rear plate
of the refrigerator.
During the automatic defrost-
ing process, frost melts on the
rear plate.
This is correct. Dry the water
with a soft cloth.
There is too much condensed
water on the rear wall of the re-
frigerator.
Door was open too frequently. Open the door only when nec-
essary.
Door was not closed com-
pletely.
Make sure the door is closed
completely.
Stored food was not wrapped. Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
13
Loading ...
Loading ...
Loading ...