Loading ...
Loading ...
Loading ...
– 14 –
FIG.
8
9.1 TILTING THE TABLE - FIG.9
Note: Remove the round cutout table insert before
tilting the table to avoid damaging the insert.
The table will tilt 0°-45°. Once the desired angle
has been set, tighten the two locking knobs found
underneath the table (FIG. 9).
Locate the oval table insert cutout and place
into the table top.
9.2 ON/OFF NO-VOLT SWITCH -
FIG.10
This sander has a On/off no volt switch with an
emergency stop function . In the event of a
power failure, the motor will not start when power
if restored.
Ensure that the sander is plugged into a suitable
13A outlet socket.
Lift the emergency stop cover to reveal the On/off
switch (Fig. 10).
To switch on, press the green button and the
sander will start. Then close the emergency stop
cover. Do not push the red button as this will cause
the motor to stop.
9.3 EMERGENCY STOP BUTTON -
FIG.11
Simply press this button to stop the machine.
There is no need to lift the cover when activating
the emergency stop button. In the event of a power
failure, the machine will not restart when the power
is restored after pressing the emergency stop
button.
9. OPERATING THE SANDER
FIG.10
FIG.11
FIG.9
Loading ...
Loading ...
Loading ...