Loading ...
Loading ...
Loading ...
STEP 4: (SEE FIGURE 4}
, Attach the brush assembly with the black brush
retainer to the left end of the brush shaft using two
1/4" x 1" hex bolts (G) and 1/4" nylock nuts (I). The
brush retainer marked with black ink must be placed
to the middle of the sweeper.
Turn a wheel to rotate the brushes. (The wheels drive
the brushes in one direction only.) The overlap bristles
should be on the back side of the brush as it rotates.
BRUSH RETAUNER
MARKED BLACK
1/4" x 1"
HEX BOLT (G)
/
1/4" NYLOCK NUT (U)
FIGURE 4
STEP 6: (SEE FIGURE 6 AND 7)
, Cut off the plastic tie that holds the height adjustment
tube in place.
Assemble the right hitch tube (stamped 06R) to the
sweeper housing using two 5/16" x 1-1/2" carriage
bolts (D), and two 5/16" nylock nuts (J). Do not tighten
yet. Repeat for the left hitch tube (stamped 05L).
5/16" x 1ol/2" /
CARRIAGE BOLT (D)/'
5/16" NYLOCK NUT (J)
FIGURE 6
R{GHT HITCH TUBE
(STAMPED 0¢R)
STEP 5: (SEE FIGURE 5)
, Assemble the angle bracket (DD) to the sweeper
housing using a 5/16" x 3/4" hex bolt (F) and a 5/16"
nylock nut (J). Make sure the bracket is turned as
shown and aligned straight with the housing and then
tighten.
5/16"
NYLOCK NUT (J)
ANGLE
BRACKET (DB}
5116"' × 314"
HEX BOLT (F) -.
Fasten the hitch tubes together using two 5/16" x
2ol/2" hex bolts (A), 5/16" small flat washers (L), and
5/16" nyiock nuts (J). Do not tighten yet.
5/16"
NVLOCK NUT (J)
/
/ ,
5/16" x 2-1/2"
REX BOLT (A)
5116"SMALL FLAT
WASHER (L)
FIGURE 7
FIGURE 5
Loading ...
Loading ...
Loading ...