Loading ...
Loading ...
Loading ...
installation 11
GENERAL INSTALLATION
Aligned to cupboard –
even gap
Top of refrigerator
is level – horizontal
Adjust front rollers for
unevenness of floor. e.g.
adjust this roller down.
Packing may be required
underneath the rear roller
to ensure stability.
4. If the appliance now rocks from one corner to the
opposite rear corner, this means that the floor is
uneven; you will need to put some packing under one
of the rear rollers.
5. You may now need to fine-tune the installation by
adjusting the front rollers once again.
ADJUSTING DOOR ALIGNMENT
Each door is independently adjustable in the vertical
direction by turning the adjustable bolts under the hinges
using the spanner provided.
Largeplasticrollernut
Front roller
Adjusting bolt
The doors can be adjusted up or down. Depending on the
amount of adjustment required it may be sufficient to adjust
only one door (refer to following diagrams).
NOTE: When the height of the rollers and adjusting bolts
are correctly adjusted the refrigerator will stand firmly on
the floor and the doors will be in line with one another.
Spanner
Spanner
INTERNAL PACKAGING
1. Please remove all internal packaging material before
use. Any glue or tape residue or the like should be
removed with a solution of mild detergent and water.
2. Clean your appliance thoroughly following the
instructions on page 32 and wipe off any dust that has
accumulated during shipping.
3. It is recommended that the refrigerator is kept upright at
all times. However if for any reason the refrigerator is laid
down, let it stand for a minimum of 1 hour before
turning on.
WARNING
Beforecleaning:Removethepowercordfromthepower
socket. This will make sure there is no chance of getting
an electric shock.
4. Install accessories such as the egg tray. The
accessories are packed together to prevent damage
during delivery.
5. Plug your appliance into the power point.
6. We recommend that you let your refrigerator run for
two to three hours before you put any food in it. This
will allow you to check that it is operating properly
and that enough cool air is circulating.
Loading ...
Loading ...
Loading ...