Loading ...
Loading ...
Loading ...
Is the dryer located in a closet?
Closet doors must have ventilation openings at the top and
bottom of the door. For most installations, the rear of the
dryer requires 5" (12.7 cm). See the Installation Instructions.
• Has an air dry modifier been selected?
Select the right temperature for the types of garments being
dried. See "Modifiers."
• Is the load too large and heavy to dry quickly?
Separate the load to tumble freely.
Cycle time too short
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
• Is the automatic cycle ending early?
The load may not be contacting the sensor strips. Level the
dryer.
Change the dryness level setting on Automatic Cycles.
Increasing or decreasing the dryness level will change the
amount of drying time in a cycle.
Do not use a dryer rack with an Automatic Cycle.
Lint on load
• Is the lint screen clogged?
Clean lint screen. Check for air movement.
Stains on load or drum
Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can
stain your garments.
Drum stains are caused by dyes in clothing (usually blue
jeans). This will not transfer to other clothing.
Loads are wrinkled
Was the load removed from dryer at the end of the cycle?
Select Touch Up Cycle to tumble the load with water and heat
to help smooth out wrinkles from a load left in the dryer. This
cycle is best for smoothing out wrinkles and reducing odors
from loads consisting of wrinkle-free cotton, cotton polyester
blends, common knits and synthetic garments.
NOTE: Refer to garment care label instructions. Dry clean
only garments are not recommended.
• Was the dryer overloaded?
Dry smaller loads that can tumble freely.
Loads are still wrinkled following SteamCare cycle?
Make sure water is connected to the dryer. Check that water
inlet hose is connected to both the faucet and dryer's water
inlet valve. Check that the water supply is turned on.
Was the dryer overloaded?
Smaller loads of 1-4 garments yeild best results with Steam
Refresh Cycle. Results may also vary depending on fabric
type. This cycle is best for reducing wrinkles and odors from
loads consisting of wrinkle-free cotton, cotton polyester
blends, common knits and synthetics.
Odors
Have you recently been painting, staining or varnishing in
the area where your dryer is located?
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
Is water connected to the dryer?
Check that water inlet hose is connected to both the faucet
and dryer's water inlet valve. Check that the water supply is
turned on.
To remove odors left in garments after wearing, select Steam
Refresh for small loads of 1-4 garments. This cycle is best for
reducing wrinkles and odors from loads consisting of wrinkle-
free cotton, cotton polyester blends, common knits and
synthetics.
24
Loading ...
Loading ...
Loading ...