Loading ...
Loading ...
Loading ...
20 21
Note: the PITT
®
cooking-system may only be connected by an approved installer. To ensure the safety and warranty
repairs may only be performed by approved professionals. You should only use original parts.
Failure Cause Solution Chapter / Page
A burner ignites and
turns off again.
The control knob is not pressed
long enough to activate the auto-
flame detection.
Press the control knob down
long enough to turn between full
and low heat.
Chapter 4 / page 18
The control knob is not adjusted at
the correct height.
Adjust the control knob properly. Installation manual **
TS: 13 t/m 15 FS: 11 t/m 17
The control-button
touches the sealing
scale.
Hob is not mounted the right way
under the countertop.
Adjust the control knob properly. Installation manual **
TS: 13 t/m 15 FS: 11 t/m 17
Sealing scale is not in the center
vs. control knob.
Detach sealing scale and and
re-stick again.
Installation manual **
TS: 20 t/m 21 FS: 16 t/m 17
Spark ignition
remains igniting.
Hob is not mounted the right way
under the countertop.
Adjust the control knob properly. Installation manual **
TS: 13 t/m 15 FS: 11 t/m 17
Sealing scale is not in the center
vs. control knob.
Detach sealing scale and and
re-stick again.
Installation manual **
TS: 20 t/m 21 FS: 16 t/m 17
The burner doesn’t
ignite.
The control knob is not adjusted at
the correct height.
Adjust the control knob properly. Installation manual **
TS: 13 t/m 15 FS: 11 t/m 17
The power plug is not in the power
socket.
Put the power plug into the
power socket.
Fuse malfunction / fuse in meter
cupboard is disabled.
Install a new fuse or switch on
the fuse again.
Spark ignition is dirty or wet. Clean or dry the spark ignition. Chapter 6 / page 19
Burner parts are not properly
mounted.
Ensure the burner parts are
correctly aligned with the
centring cams.
Chapter 6 / page 19
Burner parts are dirty or wet. Clean or dry the
burner parts. Make sure the
outflow holes are open.
Chapter 6 / page 19
The main gas supply is not open. Open the main gas supply.
The control knob is not pressed
long enough
Press the control knob down
long enough to turn between full
and low heat.
Chapter 4 / page 18
Battery empty* Replace battery Chapter 2 / page 16
A burner does not
burn evenly.
Burner parts are not placed
properly.
Ensure the burner parts are
correctly aligned with the
centring cams.
Chapter 6 / page 19
Burner parts are dirty or wet. Clean or dry the
burner parts. Make sure the
outflow holes are open.
Chapter 6 / page 19
Gas smell. Gas connection leaks. Check the connection. Turn main
gas supply off immediately when
you’re not able to fix it right
away.
There is a burner turned on, but
not inflamed.
Close the control knob and wait
a few minutes before reigniting.
Chapter 4 / page 18
7 Failures in the PITT
®
cooking system
If the failure still remains please contact your dealer or the PITT
®
cooking customer service: See the service addresses on
page 76.
* Depending on the model
** TS = Top Side / FS = Front Side
EN EN
8 Models overview Top Side
Akan Altar Azuma Air
Baluran Bennett Baula Bely
Bromo Cima Capital
Cusin Colo
Danau Drum
653
450
503
Loading ...
Loading ...
Loading ...