Loading ...
Loading ...
Loading ...
27
Also, for Stealth 875 only, you can review the number of times the slider control
bar has been used�
1� Press and hold the cancel/exit button for 3 seconds�
2� Use the scroll button and then select Cycle Counts from the menu by touching
the select button�
3� Use the scroll button to see the number of cycles run in each category�
4� Press the cancel/exit button to return to the previous menu�
Note: The pulse count refers to pulse sets. For example, touching the pulse
button 5 times in a row will register as 1 pulse count. Touching the pulse
button, then a cycle number and then the pulse button will register as 2
pulse counts.
Diagnostic Error Log
You can review the diagnostic errors that have been logged on the blender�
1� Press and hold the cancel/exit button for 3 seconds�
2� Use the scroll button and then select Diagnostic Counts from the menu by
touching the select button�
3� Use the scroll button to see the how many errors have occurred in each category�
4� Press the cancel/exit button to return to the previous menu�
Exporting Blender Statistics
Exporting blender statistics (cycle counts, errors, settings and firmware versions)
is a way to save diagnostic information, which Blendtec’s customer service and
repair experts will use if problems arise with your blender�
To export blender statistics to a USB drive, complete the following steps:
1� Use a Phillips screwdriver to remove the USB cover at the top of the right side of
the blender�
2� Plug the USB flash drive into the blender’s USB port�
Note: If the blender is in manual or automatic operation mode, the USB
flash drive menu will automatically load on the screen. If the blender is in
programming mode, go to the main menu and select USB Flash Drive.
3� Use the scroll button to find Export Counts, then press the select button� You will
be asked if you want to export counts to the sth-cnts�csv file�
4� Press the select button again to start the export process�
5� After the export process is finished, remove the USB drive from the blender and
secure the cover on the USB port with a Phillips screwdriver�
ENGLISH
Loading ...
Loading ...
Loading ...