Loading ...
Loading ...
Loading ...
English
10
Fig.G
Saw Chain and Guide Bar Oiling (Fig. A)
Auto Oiling System
This chainsaw is equipped with an auto oiling system that
keeps the saw chain and guide bar constantly lubricated.
The oil level indicator
17
shows the level of the oil in the
chainsaw. If the oil level is less than a quarter full, unplug the
chainsaw and refill with the properoil.
nOTE: Use a high quality bar and chain oil for proper saw
chain and bar lubrication. As a temporary substitute, a non-
detergent SAE30 weight motor oil can be used. The use of
a vegetable based bar and chain oil is recommended when
pruning trees. Mineral oil is not recommended because it
may harm trees. Never use waste oil or very thick oil. These
may damage yourchainsaw.
Filling the Oil Reservoir
1. Remove the oil cap
16
and fill the reservoir with the
recommended chain oil until the oil level has reached
the top of the oil level indicator
17
.
2. Refit the oilcap.
3. Periodically switch the chainsaw off and check the oil
level indicator to ensure the bar and chain are being
properlyoiled.
Attaching Extension Cord to Chainsaw
(Fig.H)
An extension cord retainer
13
is built into the
switch handle. It prevents the extension cord from
comingunplugged.
1. Double the extension cord and insert it into the slot
14
in the end of the handle area as shown in Fig.H.
2. Hook the loop formed by doubling the cord over the
cord retainer
13
. Gently tug on the cord to ensure that
it is firmly retained in thehandle.
3. Plug the receptacle end of the chainsaw power cord
12
into the extension cord adapter
15
.
4. Plug the receptacle end of the extension cord into the
extension cord adapter
15
.
NOTE: Always keep the extension cord away from the
cutting area and position the extension cord so that
it will not be caught on branches, and other material,
duringcutting.
Fig.E
5 4
1/8" (3 mm)
Fig.F
Replacing the Saw Chain (Fig.A, G)
CAUTION: Sharp chain. Always wear protective
gloves when handling the chain. The chain is sharp
and can cut you when it is notrunning.
WARNING: Sharp moving chain. To prevent
accidental operation, ensure the tool is unplugged
before performing the following operations. Failure to
do this could result in serious personalinjury.
1. Rotate the chain tensioning screw
8
counterclockwise
to lessen chaintension.
2. Remove sprocket cover
6
as described in Installing
the Guide Bar and Saw Chainsection.
3. Lift the worn saw chain
5
out of the groove in the
guide bar
4
.
4. Place the new chain in the slot of the guide bar, making
sure the saw teeth are facing the correct direction by
matching the arrow on the chain with the graphic on
the sprocket cover
6
shown in Fig.G.
5. Follow instructions for Installing the Guide Bar and
SawChain.
Loading ...
Loading ...
Loading ...