Loading ...
Loading ...
Loading ...
W415-1087 / A / 06.06.13
25
EN
7.6 LATCH BLOCK MECHANISM REPLACEMENT
!
WARNING
BURNING YOUR APPLIANCE WITH THE DOORS OPEN OR AJAR CREATES A FIRE HAZARD THAT
MAY RESULT IN A HOUSE AND OR CHIMNEY FIRE.
DO NOT STRIKE OR SLAM DOOR.
NEVER REMOVE THE DOOR WHEN THE APPLIANCE IS HOT.
A. Remove the two screws securing the latch block to the door.
B. Pull the handle towards the inside of the door and remove the latch block components, then remove
the latch block and handle support. Replace any damaged or worn components.
C. To reinstall the handle support take the latch block and handle support, align the top and bottom screw
holes to the door, as illustrated.
D. Loosely tighten the top screw and install the two pins, as illustrated.
E. Installing the spring, slip it into the bottom of the latch block and then install the screw. Apply a small
amount of high temperature grease to the spring and pins prior to installation.
HINT: compress the
spring using a fl at head screw driver, this allows for easy installation of the screw, as shown below.
F. To ensure a proper installation, the handle support should have the ability to remain in an upwards
position. Additionally, the handle support should engage smoothly with the fi rebox.
G. The handle can be permanently secured, if you choose by applying clear RTV to the inside of the
handle, then slide it into place and let cure for 24 hours.
H. Adjust the latch block up or down, angling the handle support away from the door in the closed position.
SPRING
PINS
SPRING
PINS
LATCH BLOCK
HANDLE
SUPPORT
HANDLE
E
Slide the handle onto the handle
support from the top.
Loading ...
Loading ...
Loading ...