Loading ...
Loading ...
Loading ...
11
2. Setting up the monitor
the right to conrm.
3. Toggle to the up or down to select
[PIP / PBP Mode], then toggle to the
right.
4. Toggle to the up or down to select
[PIP], [PBP], then toggle to the right to
conrm your selection.
5. Now you can move backward to set
the [PIP/PBP Input], [PIP size], [PIP
Position] or [Swap].
Toggle to the right to conrm your
selection.
MultiView in OSD menu
• PIP / PBP Mode: There are two modes
for MultiView: [PIP] and [PBP].
[PIP]: Picture in Picture
Open up a sub-window
of another signal source.
B
A (main)
When the sub source is
not detected:
B
A (main)
[PBP]: Picture by Picture
Open up a sub-window
side-by-side of other
signal sources.
BA (main)
When the sub source is
not detected.
A (main)
Note
The black strip shows on the top and
the bottom of the screen for the correct
aspect ratio when in the PBP mode. If
you expect to see full screen side by side,
adjust your devices resolutions as pop
up attention resolution, you will able to
see 2 devices source screen project to this
display side by side without black strips.
Note the analog signal is not support this
full screen in PBP mode.
• PIP / PBP Input: There are different
video input to choose as the
sub display source: [HDMI 2.0],
[DisplayPort], and [USB C].
Please refer below table for compatibility
of main/sub input source.
SUB SOURCE POSSIBILITY (xl)
Inputs HDMI Display Port USBC
MAIN
SOURCE
(xl)
HDMI
● ● ●
Display Port
● ● ●
USBC
● ● ●
• PIP Size: When PIP is activated, there
are three sub-window sizes to choose:
[Small], [Middle], [Large].
B
A (main)
Small
Middle
Large
• PIP Position: When PIP is activated,
there are four sub-window positions
to choose.
Top-Left Top-Right
B
A (main)
B
A (main)
Loading ...
Loading ...
Loading ...