Loading ...
Loading ...
Loading ...
_ FRONT INSTALLATION
Install the front grille(packed separately) onto the
cabinet as foNows:
• Hook upper tabs of front gritle into slots on the
cabinet top. (FIG. 17)
• Push front griIWs tips towards the cabinet in order
to snap side tabs into the cabinet, (FIG, 17)
• Open the inlet grille. (FIG. 18)
• Install the screw (_TEM E) through the front grille.
(FIG. 18)
• Close inlet grille, (FIG, t9)
Front Installation
FiG. 17
_EM E
Front Installation
FIG. 18
Front Installation FIG. 19
IF AIR CONDITIONER IS BLOCKED BY
STORM WINDOW FRAME
• If storm window presents interference, fasten a 2"
wide wood strip to the inner window s]l! across the full
width of the sill. The wood strip should be thick
enough to raise the height of the window sill so that
the unit can be installed without interference from the
the storm window frame. See FIG. 20.
Top d wood strip should be approximately 3/4"
higher than the storm window frame to help
condensation to drain properly to the outside,
• _nstal_a _nd w_d strip (approximately6" long by
11/2"wide and samethickr_ss as first strip) in the center
of the outer sill flush a_inst: the back of the inner sill,
Screwthe Window I_king brackets into this strip.
This will raise the, Window locking bracket as shown
in FIG 20,
WOOD STRIP MOUNTED
ON TOP OF INNER SILl,,
3/4
CLEARANCE
SILL
LOCKIt@
BPACKEO,'
WOODSTRIP
FORWINDOW
LOCK!NGBRACKED
WINDOW
FRAME
SiLL
OUTSlOE FIG, 20
REMOVAL FROM WINDOW
• Turn off and un#ug the air conditJonero
• Removethe front grille. See HOW TO REMOVETHE
FRONTGRILLE. Referto _ge 13.
• Undrew the side screwsthat you installed in Step 15,
• Slidetie air condiflo_r out of the cabinet.
BE CAREFUL NOT TO DROP IT. Holdonto it firmlythe
who_eway sliding it old, Once removed, set it safetyout
of the way,
• Removethe Window locking bracketfrom window
frameand the sash sea! from betweenthe windows,
° Unscrewthe side curtains from the window frame, Fold
them back to the sides of the cabinet.
• Removescrews attaching cabinetto inner sill. Be careDl
not to let _bJnet fail on_ screws are removed,
• Removecabinet from windowopening.
• Place air conditionerinto _bJnet. Reinstall side screws
and Front Grii_e,
° Place unit and all assembly h_dware inair conditioner
shipping carton, and store in clean, dry #ace.
• Air _nditioners covered in this manual pose an
excessive weight hazard. Two or more people
are ne_ed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
° When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
-8-
Loading ...
Loading ...
Loading ...