Loading ...
Loading ...
Loading ...
7
ENGLISH
Connecting with your devices
Arrangement (continued)
Before connecting the projector to a device, consult the manual of the device to
confirm that the device is suitable for connecting with this projector and prepare
the required accessories, such as a cable in accord with the signal of the device.
Consult your dealer when the required accessory did not come with the product or
the accessory is damaged.
After making sure that the projector and the devices are turned off, perform the
connection, according to the following instructions. Refer to figures F-3 to F-6 at the
end of this manual. For details, see User’s Manual - Operating Guide. (
1)
Before connecting the projector to a network system, be sure to read User’s Manual
- Network Guide too.
(
1)
WARNING ►Use only the appropriate accessories. Otherwise it could
cause a fire or damage the projector and devices.
• Use only the accessories specified or recommended by the projector’s
manufacturer. It may be regulated under some standard.
• Neither disassemble nor modify the projector and the accessories.
•
Do not use the damaged accessory. Be careful not to damage the accessories.
Route a cable so that it is neither stepped on nor pinched out.
CAUTION ►For a cable with a core at only one end, connect the end with
the core to the projector. That may be required by EMI regulations.
►Before connecting the projector to a network system be sure to obtain the
consent of the administrator of the network.
►
Do not connect the LAN port to any network that might have the excessive voltage.
►The designated USB wireless adapter that is sold as an option is required to
use the wireless network function of this projector.
►Before removing the USB storage device from the port of the projector, be
sure to use the REMOVE USB function on the thumbnail screen to secure your
data. Before you insert or pull out the USB wireless adapter from the projector,
turn off the power of the projector and pull out the power cord’s plug from the
outlet. Do not touch the USB wireless adapter while the projector is receiving
AC power.
(continued on next page)
NOTICE ►Position the projector to prevent light from directly hitting the
projector’s remote sensor.
►Positional deviation or distortion of a projected image, or shift of the focus
may occur due to ambient conditions, and so on. They tend to occur until the
operation becomes stable, especially within about 30 minutes after the lamp is
turned on. Check and readjust them as necessary.
►Do not place the product in a place where radio interference may be caused.
►Check and correct the setting for ALTITUDE of SERVICE in the OPTION
menu according to the usage environment. For details, see User’s Manual -
Operating Guide. (
1)
Loading ...
Loading ...
Loading ...