Loading ...
Loading ...
Loading ...
page 8
9. Light Kit Assembly (Optional). (cont.)
metal cover
diagram 3
diagram 2
Remove 1 screw from post on underside of
fitter plate and partially loosen the other 2
screws.
Connect WHITE wire from motor housing to
WHITE wire from LED light kit. Connect BLACK
(or BLUE) wire from motor housing to BLACK
wire from LED light kit. Be sure molex
connections snap together securely. [Refer to
diagram 2.]
CAUTION: If you will NOT be using the light kit,
do NOT connnect the molex connections.
Carefully arrange wiring in center of fitter plate.
WARNING: Do NOT allow wires to remain
outside of posts as this could damage the wires.
WARNING: Make sure wires do not get pinched
in between LED light kit and post(s) on fitter
plate. This could cause damage to the wire(s).
Align slotted holes in LED light kit with
loosened screws in fitter plate. Twist LED light
kit to lock. Re-insert screw that was previously
removed and tighten all 3 screws with a Phillips
screwdriver. [Refer to diagram 2.]
If you wish to use the light kit, align grooves on
glass shade with nodules on inside of LED light
kit and push up gently on glass shade. Twist
glass shade to the RIGHT (clockwise) until glass
shade no longer turns. [Refer to diagram 2.]
NOTE: The use of rubber grip gloves are
recommended should you need to remove the
glass shade.
If you do NOT wish to use the light kit, locate
slots on metal cover and align with nodules
inside LED light kit. Push up on metal cover and
turn to the RIGHT (clockwise) until it no longer
turns. [Refer to diagram 3.]
WARNING: If you do not wish to use the light kit,
do NOT connect the molex connections for the
LED light kit.
CAUTION: Metal cover will be HOT if light is left
on.
LED
light kit
glass shade
motor
housing
fitter plate
molex
connections
Loading ...
Loading ...
Loading ...