Loading ...
Loading ...
Loading ...
OPERATION
I
The operation of any tractor can result in foreign objects thrown into the eyes, which can result |
in severe eye damage. Always wear safety glasses or eye shields while operating your tractor
I
or performing any adjustments or repairs. We recommend a wide vision safety mask over
spectacles or standard safety glasses.
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE (See Fig. 8)
Yourtractor isequipped with anoperator presence sensing
switch. When engine is running, any attempt by the
operator to leave the seat without first setting the parking
brake will shut off the engine.
• Depress clutch/brake pedal into full "BRAKE" position
and hold.
• Place parking brake lever in"ENGAGED" position and
release pressure from clutch/brake pedal. Pedal should
remain in "BRAKE" position. Make sure parking brake
will hold tractor secure.
THROTTLE CHOKE
CONTROL CONTROL
CLUTCH/
BRAKE PEDAL
"BRAKE"
PosmoN
ATTACHMENT
CLUTCH SWITCH
PULL OUTTO
"ENGAGE"
PUSH-INTO
"DISENGAGE"
MORON
CONTROLLEVER
PARING BRAKE
"DRIVE" HEIGHT "ENGAGED"POSITION
PosmoN ADJUSTMENT
KNOB "DISENGAGED"
POSITION
FIG. 8
STOPPING (See Fig. 8)
MOWER BLADES -
To stop mower blades,move attachment clutchswitch
to =DISENGAGED position.
GROUND DRIVE -
• To stop ground drive, depress clutch/brake pedal into
full =BRAKE"position..
• Move motion control lever to neutral (N) position.
IMPORTANT: THE MOTION CONTROL LEVER DOES
NOT RETURN TO NEUTRAL (N) POSITION WHEN THE
CLUTCH/BRAKE PEDAL IS DEPRESSED.
ENGINE -
• Move throttle control to slow position.
NOTE: Failure to movethrottle controlto slowpositionand
allowing engine to idle before stopping may cause engine
to "backfire".
• Turn ignition key to =OFF" position and remove key.
12
Always remove key when leaving tractor to prevent
unauthorized use.
• Never use choke to stop eng!ne.
IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY
POSITION OTHER THAN "OFF" WILL CAUSE THE
BATTERY TO BE DISCHARGED. (DEAD).
NOTE: Under certain conditions when tractor is standing
idle with the engine running, hot engine exhaust gases may
cause "browning" of grass. To eliminate this possibility,
always stop engine when stopping tractor on grass areas.
pletely, as described above, before leav-
ing the operator's position; to empty
grass catcher, etc.
TO USE THROTrLE CONTROL (See Fig. 8)
Always operate engine at full throttle.
Operating engine at less than full throttle reduces the
battery charging rate.
• Full throttle offers the best mower performance.
TO USE CHOKE CONTROL (See Fig. 8)
Use choke controlwhenever you are startinga coldengine.
Do not use to start a warm engine.
• To engage choke control, pull knob out. Slowly push
knob in to disengage.
TO MOVE FORWARD AND BACKWARD
(See Fig. 8)
The direction and speed of movement iscontrolled by the
motion control lever,
° Start tractor with motion control lever in neutral (N)
position.
• Release parking brake and clutch/brake pedal,
• Slowly move motion control lever to desired position,
TO ADJUST MOWER CUTTING HEIGHT
(See Fig. 8)
The cuttingheight iscontrolledbyturningthe heightadjust-
ment knob in desired direction.
Turn knob clockwise (/'_) to raise cutting height.
• Turn knob counterclockwise (P'_) to lower cutting
height.
The cuttingheight range isapproximately 1-1/2" to 4". The
heights are measured from the ground to the blade tip with
the engine not running. These heights are approximate
and may vary depending upon soil conditions, height of
grass and types of grass being mowed.
• The average lawn shouldbecuttoapproximately 2-1/2
inches during the cool season and to over 3 inches
during hot.months. For healthier and better looking
lawns, mow often and after moderate growth.
Loading ...
Loading ...
Loading ...