Loading ...
Loading ...
Loading ...
OPERATION TIPS
Terms
Preparation
Pressure Washing
•PSI-Poundspersquareinch(PSI)istheunittomeasurethepressureofwater.Inrelation
to a pressure washer, the higher the PSI number, the greater the pressure and stripping
power produced.
•GPM-Gallonsperminute(GPM)istheowrateofwater.Inrelationtoapressurewasher,
thegreatertheGPM,thegreatertheoworrinsingpowerproduced.
• CU- Cleaning unitsexpress theeciency ofthe pressure washer.Cleaningunits are
calculated by multiply the PSI by the GPM. The higher the CU, the more ecient the
pressure washer.
• Read all warning and instructions in this and all manuals that came with the pressure washer.
• Remove all toys, bikes, lawn furniture, etc. from the work area if they are not to be cleaned.
• Sweep any loose dirt and debris from the surface you will be pressure washing.
• Cover nearby plants to avoid damaging them with the pressure washer spray.
• Use caution when spraying windows. Always use the white, 40
o
nozzle and stay at least 4 feet away.
•Laytarpsdowntocollectpaintchipsandotherdebrisblowno�bythespray.Exteriorpaints
used before 1977 may contain lead and will produce chips that will need to be collected and
disposed of at a hazardous waste facility.
•Awidersprayequalsfastercleaning,whileatightersprayequalsdeepercleaning.
• Keep the nozzle about 4 feet away from siding to avoid damage.
• Start washing siding at the bottom and work your way up, then rinse from the top down.
• Avoid driving water up behind siding.
• Use overlapping strokes for even cleaning.
• Work in small areas to keep the soap from drying.
• Do not aim the nozzle straight at the surface. Hold the wand at a 45
o
angle to the surface at a distance
that cleans well without causing damage.
Adjusting Pressure
The pressure setting is preset at the factory to achieve optimum pressure and cleaning. If
you should need to lower the pressure, it can be accomplished by the following methods.
• Back away from the surface to be cleaned. The further you position the nozzle from the surface to be
cleaned, the lower the pressure to reach the surface.
• Change to the white, 40
o
nozzle. This nozzle produces a lower pressure, wider width spray.
NOTE: Do not overtighten the pressure control knob. If overtightened, the knob COULD break
causing immediate loss of pressure and costly repairs not covered by the warranty.
Your unit may be equipped with an additional
feature that allows you to adjust the pressure.
To lower the pressure, turn the knob counter-
clockwise to the desired pressure.
To return the pressure to the factory setting, turn
the knob clockwise until it stops.
Page 23
Loading ...
Loading ...
Loading ...