134472900 0411
STACKING INSTRUCTIONS
Tumble Action Washer/Dryer
To reduce the risk of electrical shock, disconnect this appliance from the power supply
before attempting any user maintenance. Turning the controls to the OFF position does not disconnect this
appliance from the power supply.
Refer to the washer and dryer installation instructions packed with each appliance prior to
stacking appliances. Reading all of the information contained in these instructions will simplify the installation
and ensure a correct and safe operation. A fire hazard and/or personal injury could result from improper
installation.
TOOL & EQUIPMENT REQUIREMENTS:
1. Phillips screwdriver.
KIT COMPONENTS
1 - Installation Instructions
2 – Plastic rear brackets 6 – #10-16 x .375 inch screws
1 – Front spacer
A. Install Rear Brackets and Front Support Spacer
1. Install two (2) rear brackets with four (4) #10-16 x .375 screws on
rear of top panel as shown (Picture 1).
Picture 1
2. Clean front portion of top panel with isopropyl alcohol to prepare
surface for front spacer placement (Picture 3).
3. Peel off backing of tape on the bottom side of the front spacer.
Place spacer on the top panel, lining up the rear edge of each slot
in the spacer with the seam between the top panel and console as
shown (Pictures 2 & 3).
Picture 2 Picture 3
B. Stack the Dryer
1. Have two or more people lift the dryer onto the washer. While
supporting the front of the dryer, carefully push the dryer back until
the rear legs slide into the two (2) rear brackets (Picture 4).
Picture 4
2. Lower the front legs into the front spacer as shown (Picture 5).
Picture 5
3. Install two (2) #10-16 x .375 screws through the tab on the front
spacer and into the hole in the service panel bracket as shown
(Picture 6).
Picture 6
C. Washer and Dryer Operation
Refer to the washer and dryer installation and operating instructions for
proper installation and operation.
WARNING
WARNING
Loading ...
