Loading ...
Loading ...
Loading ...
EN - 9
5.5
Used to turn on the engine when cold. The
choke control has two positions (Fig. 12.E):
Position A - the choke is not engaged
(normal operations and warm start).
Position B - the choke is
engaged (for a cold start).
5.6 PRIMER CONTROL BUTTON
Press the rubber button of the
primer to inject fuel into the
carburettor to facilitate startup when
the engine is cold (Fig. 12.F).
6. USING THE MACHINE
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or dangers.
IMPORTANT The machine
is supplied without fuel.
6.1 PRELIMINARY PROCEDURES
Before using the machine:
1. place the machine in a stable
horizontal position on the ground;
2. choose the most suitable cutting means
for the job to be done (par. 4.3);
3. perform refuelling. For fuel lling methods and
precautions (see par. 7.2 and paragraph 7.3);
4. wear the harness correctly
(see paragraph 6.1.1).
6.1.1 Using the harness
The harness and straps must be adjusted
to suit the operator’s height and stature.
Always use a harness that is suited
to the weight of the machine:
– for machines weighing less than 7.5 kg,
single or double belt models can be used;
– only the double belt model must be used
for machines weighing more than 7.5 kg.
• Models with single belt
The harness must be put on before connecting
the machine to the special coupling.
The belt (Fig. 13.A) must go from the
left shoulder to the right hip.
The belt must be worn with:
– the support (Fig. 13.A.1), the machine
coupling clip (Fig. 13.A.2). and
the quick release clip (Fig. 13.A.3)
positioned on the right side.
• Models with double belt
The harness must be put on before connecting
the machine to the special coupling.
The belt (Fig. 13.B) must be worn with:
– the support (Fig. 13.B.1), the machine
coupling clip (Fig. 13.B.2). and
the quick release clip (Fig. 13.B.3)
positioned on the right side.
– the quick release clip on the
front (Fig. 13.B.3);
– the belts cross-over on the
operator’s back (Fig. 13.B.4);
– the buckles correctly tted (Fig. 13.B.5).
The belts must be tensioned so that the load
is evenly distributed on the shoulders.
6.2 SAFETY CHECKS
Run the following safety checks and
check that the results correspond to
those outlined on the tables.
Always carry out the
safety checks before use.
6.2.1
Result
Hand grips (Fig. 1.F,
Fig. 1.G, Fig. 1.I)
Clean, dry and xed
rmly to the machine.
Cutting means
guard. (Fig. 1.E)
Suitable for the cutting
means used, xed
correctly and rmly to
the machine, not worn/
deteriorated or damaged.
Connection point of
the harness (Fig. 1.J)
Correctly positioned.
Quick release clip
(Fig. 13.A.3, Fig. 13.B.3)
Ecient. Must enable
the machine to be
freed rapidly in the
event of danger.
Screws on the machine
and on the cutting means
Correctly tightened
(not loose)
Loading ...
Loading ...
Loading ...