Loading ...
Loading ...
Loading ...
Theoperationofanytillercanresultinforeignobjectsthrownintotheeyes
whichcanresultinsevereeyedamage.Awayswearsafetyglassesoreye
shieldsbeforestartingyourtillerandwhiletilling.Werecommendawide
visionsafetymaskoverspectaclesorstandardsafetyglasses.
HOWTOUSEYOURTILLER
Knowhowtooperateallcontrolsbefore
addingfuel and oil or attempting to start
engine.
STOPPING
TINES
• Release Une control to stop movement.
ENGINE
• Move throttle control to =STOP" posi-
tion.
NOTE: Never use choke to stop engine.
TineControl
"Off" (UP) Position
"On"(DOWN) Position_ "
WHEELS
Adjustwheelsby removingthe hairpin
clipand clevispin. Changewheel
position. Replacethe hairpinclipand
clevispin.
• Fornormaltilling,set wheelsat the
secondor thirdholefromthetop.
\
HairpinClipand
Depth
Stake
HairpinClip
andClevisPin
Chokq
Control
Contmt
TINE OPERATION
• Squeeze Une control to handle.
TILLING
The speed and depth of tilling is regu-
lated by the position of the depth stake
and wheel height.
The depth stake should always be below
the wheels for digging, it serves as a
brake to slow the tiller's forward motion to
enable the tines to penetrate the ground.
Also, the more the depth stake is lowered
into the ground the deeper the tines will
dig.
DEPTH STAKE
Adjust depth stake by removing the
hairpin clip and clevis pin. Change depth
stake to desired position. Replace the
clevis pin and hairpin clip.
• For normal tilling, set depth stake at the
second or third hole from the top.
TO TRANSPORT
ACAUTION: Before lifting or transporting
allow tiller engine and muffler to cool.
Disconnect spark plug wire. Drain
gasoline from fuel tank.
AROUND THE YARD
1. Tip depth stake forward until it is held
by the stake spdng.
2. Push tiller handles down, raising tine._
off the ground.
3. Push or pull tiller to desired location.
AROUND TOWN
1. Disconnect spark plug wire.
2. Drain fuel tank.
3. Transport in upright position to
prevent oil leakage.
BEFORE STARTING ENGINE
IMPORTANT: Be very careful not to allow
dirt to enter the engine when checking or
adding oil or fuel. Use clean oil and fuel
and store in approved, clean, covered
containers, use clean fill funnels,
FILL ENGINE WITH OIL
1. Remove hangtag from engine.
2. With engine level, remove engine oil
filler plug.
3. Fill engine with oil to point of overflow
ing. For approximate capacity see
=PRODUCT SPECIFICATIONS" on
page 4 of this manual. All oil must
meet A.P.I. Service Classification SF-
SJ.
8
Loading ...
Loading ...
Loading ...