Loading ...
Loading ...
Loading ...
InstallationInstructions.
[]
Read theseinstructionscompletelyand carefully.
4-Wire Power Cord Installation
WARNING:Theneutralwireof
the supply circuit is connected to the neutral
terminal located in the center of the connector
block. Thepower leads must be connected to
the outside (brass-colored) terminals. The4th
grounding lead must be connected to the
frame of the range with the grounding plate
and grounding screw.
A. Renlove tile 3 screws tiom tile connector block.
B°
C°
Remove tile grounding screw and strap fiom tile
connector block iniddle location and tile screw
connection to tile fiame of the range.
Insert soews through each power cord teHninal
ring and into connector block until screw
engages nut. Be certain that the center wire is
connected to the center scI'ew ofthe connectoi
block. Tighten screws securely.
D. AttaOl ground xdre to tile fiame of the range.
Before
Neutralterminal
i
GroundStrap
(groundingto range)
After
Neutralterminal
'ra°'Uen '°O
Groundingto range"
[]
3-Wire Condu# Installation
Renl(we tile 3 so'ews fi'om tile connector block.
hlsert bare wires belween the connector block
terminals and movable ntlts. Tighten so'ews
securely. Do not remove ground suap connection.
WARNING: Connector block is approved for
copper wire connection only. If aluminum wire
is used, see note below.
NOTE:ALUMINUM WIRING
A°
B°
1)O not connect altllilinuiil wiie to tile conne(TU)i
block.
Use copper buikfing wire rated for tile correct
amperage and voltage to make three 3" copper
jumper wires. ( onnect wire as per Step 6or 7
depending on number ofxdres.
Splice copper wires to ahmlinum wMng using
special connector terminals designed and
UL-approved fi,rjoining copper to aluminum
and tbllow tile connector mamltimuner's
recommended procedure closely.
Wireused,locationandenclosureofsplices,etc.,must
conformtogoodwiringpracticesandlocalcodes.
"__ Screw
_°n'm'i_ctiorbl°ck
I
Barewire -_,-_,'*_
Movablenut'------_ _ _'_
Flexiblecable
/
Bracket
32
Loading ...
Loading ...
Loading ...