Loading ...
Loading ...
Loading ...
ASSEMBLY
Read these instructions and this manual in its entirety before
you attempt to assemble or operate your new lawn mower.
IMPORTANT: THIS LAWN MOWER IS SHIPPED WITH-
OUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been assembled at the factory
with the exception ofthose parts left unassembled for ship-
ping purposes. All parts such as nuts, washers, bolts, etc.,
necessary to complete the assembly have been placed in
the parts bag. To ensure safe and proper operation of your
lawn mower, all parts and hardware you assemble must
be tightened securely. Use the correct tools as necessary
to ensure proper tightness.
TO REMOVE LAWN MOWER FROM CARTON
1. Remove loose parts included with mower.
2. Cut down two end corners of carton and lay end panel
down flat.
3. Remove all packing materials except padding between
upper and lower handle and padding holding operator
presence control bar to upper handle.
4. Roll lawn mower out of carton and check carton thor-
ougly for additional loose parts.
HOWTO SET UPYOUR LAWN MOWER
TO UNFOLD HANDLE (See Figs. 1 and 2)
IMPORTANT: UNFOLD HANDLE CAREFULLY SO AS
NOTTO PINCH OR DAMAGE CONTROL CABLES.
1. Raise lower handle section to operating position and
align hole in handle with one of three height positioning
holes.
2. Insert handle bolt through handle and bracket and
secure with knob.
3. Repeat for opposite side of handle.
4. Remove protective padding, raise upper handle section
into place on lower handle and tighten both handle knobs.
5. Remove any packing material from around control bar.
Your handles may be adjusted for your mowing comfort.
Refer to"ADJUST HANDLE"in the Service and Adjustments
section of this manual.
OPERATOR PRESENCE
CONTROLBAR
UPPER HANDLE
LOWER HANDLE
LIFT
MOWING
POSITION
KNOB
HANDLE
BRACKET
FIG. 2
TO ASSEMBLE GRASS CATCHER
(See Fig. 3)
1. Put grass catcher frame into grass bag with rigid part
of bag on the bottom. Make sure the frame handle is
outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE: Ifvinyl bindings are too stiff, hold them in warm water
for a few minutes. If bag gets wet, let it dry before using.
CATCHER
FRAME
HANDLE
\
FIG. 3
FRAME
OPENING
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a
mulcher. To convert mower to bagging or discharging,
see "TO CONVERT MOWER" in the Operation section of
this manual.
FIG. 1 4
Loading ...
Loading ...
Loading ...