Loading ...
Loading ...
Loading ...
Before lnstaHingTheWater Supply Line,You Will Need
,' Basic Tooms: adjustabIe wrench, flat-blade screwdriver,
and Phillipd rMscrewdriver
,, Access to a household cold water line with water pressure
between 30 and 100 psi=
* A water supply line made of ¼ inch (6=4 mm) OD, copper
tubing= To determine the length of copper tubing needed,
you will need to measure the distance from the ice maker
inlet valve at the back of the beverage center to your cotd
water pipe= Then add approximately 7 feet (2=1 meters), so
the beverage center can be moved out for cleaning (as
shown).
* A shutoff valve to connect the water supply line to your
household water system= DO NOT use a self-piercing type
shutoff valve=
,, A compression nut and ferrule (sleeve) for connecting the
water supply line to the ice maker inlet valve.
To Connect Water Supply LineTo ice Maker inJet VaJve
1= Disconnect beverage center from electric power source=
2= Place end of water supply line into sink or bucket. Turn ON
water supply and flush supply line until water is clear= Turn
OFF water supply at shutoff valve=
3= Unscrew plastic cap from water valve inlet and discard
cap.
4= Slide brass compression nut, then ferrule (sleeve) onto
water supply line, as shown=
5= Push water supply line into water valve inlet as far as it
will go (¼ inch)= Slide ferrule (sleeve) into valve inlet and
finger tighten compression nut onto valve= Tighten another
half turn with a wrench; DO NOT over tighten=
6= With stee! clamp and screw, secure water supply line to
rear panel of beverage center as shown=
7= Coil excess water supply line (about 2½ turns) behind
beverage center as shown and arrange coils so they do
not vibrate or wear against any other surface=
8= Turn ON water supply at shutoff valve and tighten any
connections that leak=
9= Reconnect beverage center to electrical power source=
10= To turn ice maker on, lower wire signal arm (see ice
maker front cover for ON/OFF position of arm).
Plastic Water
Tubing to _ce Make{
Brass
Comeressior
er Valv6
Bracket
from household water supply
qndude enough tubing in oop to a_bw
mown_ refrigerator out for cleaning v
Loading ...
Loading ...
Loading ...