Loading ...
Loading ...
Loading ...
DELIVERYHOSEARRANGEMENT
,, Inserttheclearhose(12)(deliveryhose)intothehose
routingclipsattachedtothedoorandthecabinet.Foilow
thehoseroutingshownbelowdependingonthedoor
swingdirectionofyourdoor.
]Li '_ii!iiiiii!iii!i!i!iiiiii!ii!!ii_;ii!;!iiiiiiiii_i!;!ii:_',iiiii!ii!iiiiii_iii!iiiiii!ii!!ii_;ii!;!iiiiiiiii_i!;!ili
Left Hand Swing
i!iiii iiii
Hight Hand Swing
OPERATINGYOUR BEVERAGE CENTER
,, Make sure that the beverage center is plugged in properly
to a 115V, 60Hz AC onty electrical outlet. Refer to
Electrical Information on page 3.
,, Make sure that the drip tray and sump are secured under
the faucet.
,, Start with a clean beverage glass that has been wetted in
cold water. Piace the gtass at a 45 ° angle, one inch below
the faucet. Do not let the glass touch the faucet. Open the
faucet alI the way.
,, After the glass has reached half full, gradually bring the
glass to an upright position.
,, Let the remaining beverage run straight down the middle.
This insures proper release of CO 2 by producing a 3A" to a
1" foam head.
,, Close the faucet completely and quickly.
HOWTO REPLACE AN EMPTY CO 2 CANISTER
" Remove hoses from routing clips.
,, Remove the keg, then remove CO 2canister=
,, Close the canister vaIve of the empty canister by turning
clockwise untii it stops=
,, Close the regulator shut-off valve by moving it to the 9
o'clock position.
,, Carefully remove regulator from the empty CO 2 canister by
loosening the nut with an adjustable wrench. Check the
condition of the gasket inside the nut and replace if
necessary.
,, Return canister to your local carbonic gas source for filling.
(We suggest looking in your yellow pages under
"Carbonic Gas". Sources of CO2vary from community to
community but it is often available at welding supply
stores and beverage distributors.)
,, Remove dust cap from new canister nut, if any.
,, With the canister valve still in closed position, reattach the
regulator to the new canister using an adjustable wrench.
Ensure the plastic washer is inside of the nut. Tighten nut
until it feels snug but be careful not to over tighten as you
will damage the gasket inside the stem nut.
,, Check to make sure that the braided gas line hose is still
securely attached to the regulator.
,, Open the canister valve all the way by turning counter-
clockwise until it stops. This valve seals at both the fully
open and fully closed positions. Failure to completely open
or close the valve could result in premature loss of CO 2
pressure.
,, Open the regulator shut-off valve by moving it down to the
6 o'clock position.
,, Check gauge pressure. Adjust the regulator adjustment
screw as necessary until the pressure reads between 12
to 14 psi. Tighten the adjustment Iock nut.
,, Replace keg and route hose clips.
12
Loading ...
Loading ...
Loading ...