Loading ...
Loading ...
Loading ...
5.
6.
7.
[] The washer will not fill, but the basket will rotate while
the washer runs a short sensing cycle. This will take
approximately 3 minutes.
The cycle will determine whether clothing or other items are
in the washer.
a} If no items are detected in the washer, it will proceed
to Step 7.
b} If any items are detected in the washer, "rL" or "F-34"
will be displayed. Then the door will unlock.
[] Press COLD to cancel the failure code. Then repeat
steps 1, 3, and 4 to start the cycle again.
Once the cycle has begun, allow the cycle to complete.
After the cycle is complete, leave the door open slightly,
to allow for better ventilation and drying of washer interior.
Always do the following to maintain washer freshness
[] Use only"HE" High Efficiency detergent.
[] Leave the door slightly open after each cycle to allow
for
better ventilation and drying of washer interior.
[] Clean the washer monthly using the Washer Maintenance
Procedure, and 2/3 cup (160 mL) of liquid chlorine bleach.
[] If the procedure does not sufficiently improve the machine
freshness, please evaluate your installation and usage
conditions for other causes.
Cleaning the exterior
Use a soft damp cloth or sponge to wipe up any spills.
Occasionally wipe the outside of your washer to keep it looking
new. Use mild soap and water. Do not use abrasive products.
Cleaning the dispenser drawer
........................................................................................................................................... r
The dispenser drawer is removable for easy cleaning.
1. Unlock the dispenser drawer by pressing the Release Lever.
Remove the drawer.
2. Remove the inserts (the siphon from the softener and bleach
compartments).
3. Wash the parts under running water.
NOTE: Do not wash components in the dishwasher.
4. Replace the inserts and return the dispenser to the drawer.
Replace water inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace water inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your water inlet hoses, mark the date of
replacement on the label with a permanent marker.
ASS(STANCEOR SERVICE
If you need assistance:
Contact the distributor where the washer was purchased or visit
www.whiripooicommerciaHiaundry.com.
When you call, you will need the washer model number and serial
number. Both numbers can be found on the serial-rating plate
located on your washer.
13
Loading ...
Loading ...
Loading ...