Kenmore 10650444903 Elite refrigerator

User Manual - Page 13

For 10650444903.

PDF File Manual, 96 pages, Download pdf file

Loading ...
Loading ...
Loading ...
5=
NOTE: While dispensing water, the digital display will count
down how much water remains to be dispensed, according
to the volume you selected. The flow of water will
automatically stop once the desired volume has been
dispensed.
To stop dispensing before the selected volume has been
dispensed, remove the glass from the dispenser pad OR
press the water dispenser button a second time.
NOTE: If you stop dispensing before the desired volume has
been dispensed, the digital display will continue to show how
much water remains to be dispensed. The display will exit the
Measured Fill screen after 15 seconds of inactivity.
To select a new volume or select the same volume again, you
must first finish dispensing the selected volume, or turn off
the Measured Fill feature and then turn it back on.
Preset Volumes
The dispenser can store up to three preset water volumes, for
easy dispensing into commonly used containers.
To store presets, press WATER, press UNITS to select your
desired setting, and use the arrows to adjust the volume of
water as desired. Locate a blank or unwanted preset on the
display screen. Press and hold that preset for 3 seconds, and
the preset volume will be saved.
To use presets, press WATER, then press and release the
desired preset. Dispense water as instructed in steps 4 and 5
of the previous section.
Rotating Faucet and Pull-out Tray (on some models)
Your dispenser may include a rotating water faucet and a small
pull-out tray at the bottom of the dispenser.
A. Faucet rotated
B. Pull-out tray
The faucet rotates to the center to allow for easy dispensing
into large containers. To rotate it, push in and release the left-
hand side of the faucet as shown.
The faucet rotates to the center automatically. However, you
must rotate it back into place manually. When in place, it will
click.
NOTE: When using the dispenser with the faucet rotated, do
not use the water dispenser pad. Only use the water
dispenser button to dispense. Dispensing by pressing the
container against the water dispenser pad may result in
unintentional spilling.
The tray can be pulled out approximately 11/2"(3.81 cm) to
better support large containers. It is designed to catch small
spills and allow for easy cleaning. There is no drain in the tray.
NOTE: The tray can be removed from the dispenser and
carried to the sink to be emptied or cleaned. Pull the tray out
until it hits the stop, then gently lift up on the back of the tray
and slide it out the rest of the way.
The Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer when
the dispenser pad is pressed. The dispensing system will not
operate when the freezer door is open. To turn off the ice maker,
see "Ice Maker and Storage Bin."
Your ice maker can produce shaved, crushed and cubed ice.
Before dispensing ice, press ICE on the display screen to select
which type of ice you would like to dispense.
The display screen indicates which type of ice is selected.
SHAVED CRUSHED CUBED
For shaved or crushed ice, cubes are shaved/crushed before
being dispensed. This may cause a slight delay when dispensing
shaved or crushed ice. Noise from the ice crusher is normal, and
pieces of ice may vary in size. When changing from crushed to
cubed, a few ounces of crushed ice will be dispensed along with
the first cubes.
To change your ice dispensing preferences, press
FEATURES, then PREFERENCES, then ICE.
The default setting always uses the same type of ice that was
selected the last time the dispenser was used.
You can change the setting to remember your preferred type
of ice. If the ice type is then changed, the newly selected
setting will be used for 3 minutes. After 3 minutes have
passed, the ice type will return to your saved preference.
Wait 15 seconds or press BACK, and the preference change
will be saved.
To Dispense Ice:
1. Select the desired type of ice.
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2=
Press a sturdy glass against the ice dispenser pad OR place
the glass below the ice dispenser and press the ice dispenser
button.
fill
Hold the glass close to the dispenser opening so ice does not
fall outside of the glass.
13
Loading ...
Loading ...
Loading ...