Loading ...
Loading ...
Loading ...
49-2000930 Rev. 0 15
Installation Preparation - UVC9420 and UVC9480
POWER SUPPLY
IMPORTANT – (Please read carefully)
WARNING
FOR PERSONAL SAFETY, THIS APPLIANCE
MUST BE PROPERLY GROUNDED.
Remove house fuse or open circuit breaker before
beginning installation.
Do not use an extension cord or adapter plug with
this appliance. Follow National Electrical Codes or
prevailing local codes and ordinances.
Electrical supply
These vent hoods must be supplied with 120V,
60Hz, and connected to an individual, properly
grounded branch circuit, and protected by a 15 or 20
amp circuit breaker or time delay fuse.
Ŷ Wiring must be 2 wire with ground.
ŶIf the electrical supply does not meet the above
requirements, call a licensed electrician before
proceeding.
ŶRoute house wiring as close to the installation
location as possible in the ceiling or wall.
ŶConnect the wiring to the house wiring in
accordance with local codes.
Grounding instructions
The grounding conductor must be connected to
a ground metal, permanent wiring system, or an
equipment-grounding terminal or lead on the hood.
WARNING
The improper connection of the
equipment-grounding conductor can result in a risk
of electric shock. Check with a qualified electrician
or service representative if you are in doubt whether
the appliance is properly grounded.
PREPARE HOUSE ELECTRICAL
WIRING
The custom cabinet must allow spacing for house
wiring to reach junction box located in diagram
below. If unit is installed over an island, the wiring
must come from ceiling. If power cord is needed,
accessory is available.
PREPARE THE HOOD FOR
INSTALLATION
NOTE: For transportation purposes the motor
assembly is secured by 2 brackets. They must be
removed prior to installation and discarded.
ŶPlace insert hood canopy on padded, yet stable,
surface below cutout (can use flattened carton to
pad surface).
ŶRemove the junction
box cover. The junction
box is located inside
the top left side of the
hood.
ŶSave the junction
box cover and
screws. They will be
needed at installation.
ŶRemove the 12 screws from the brackets
over the motor assembly to remove the brackets.
The junction box is
located in this area
inside the hood.
Electrical
Area
24"
Brackets
Screws
INSTALLATION PREPARATION
Loading ...
Loading ...
Loading ...