Loading ...
Loading ...
Loading ...
5. HEALTH AND SAFETY INFORMATION
- 8 -
c) Wear protective goggle while operating.
d) to prevent dust irritation, the wearing of a face mask is recommended.
e) Before using, check the supply and extension cord for signs of damage and aging.
Do not use the appliance if the cord is damaged or worn.
f) Never operate the appliance with defective guards or shields, or without safety devices, for
example debris collector in place
g) Only use a weather proof extension cable fitted with a coupler according to IEC 60320-2-3.
3. Operation:
a) Always direct the cable to the rear away from the appliance.
b) If a cord becomes damaged during use, disconnect the supply cord from the main
immediately.
DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY.
c) Do not carry the appliance by the cable.
d) Disconnect the appliance from the main supply:
- Whenever you leave the machine.
- Before cleaning a blockage.
- Before checking, cleaning or working on the appliance.
- If the appliance starts to vibrate abnormally.
e) Operate the appliance only in daylight or in good artificial light.
f) Do not overreach and keep your balance at all times.
g) Always be sure of your footing on slopes.
h) Walk, never run.
i) Keep all cooling air inlets clear of debris.
j) Never blow debris in the direction of bystanders.
4. Maintenance & Storage:
a) Keep all nuts, bolts and screws tight to be sure the appliance is in safe working condition.
b) Check the debris collector frequently.
c) Replace worn or damaged parts.
d) Use only genuine replacement parts and accessories.
e) Store the appliance only in a dry place.
5.3 CONNECTION TO THE POWER SUPPLY
Caution: Risk of electric shock. Do not open.
This appliance is supplied with an approved plug and cable for your safety. The value of the fuse
fitted is marked on the pin face of the plug. Should the fuse need replacing, ensure the substitute
is of the correct rating, approved to BS1362 and ASTA or BS Kite marked.
ASTA
BSI
The fuse cover is removable with a small plain slot screwdriver. Ensure the fuse cover is replaced
before attempting to connect the plug to an electrical outlet. If the cover is missing, a replacement
must be obtained or the plug replaced with a suitable type.
If a replacement plug is to be fitted this must be carried out by a qualified electrician.
The damaged or incomplete plug, when cut from the cable should be disabled to prevent
connection to a live electrical outlet.
This appliance is Class II† and is designed for connection to a power supply matching that
detailed on the rating label and compatible with the plug fitted.
If an extension lead is required, use an approved and compatible lead rated for this appliance.
Follow all the instructions supplied with the extension lead.
†Double insulated This product requires no earth connection as supplementary insulation is
applied to the basic insulation to protect against electric shock in the event of failure of the basic
insulation.
IMPORTANT
If using an extension lead, follow the instructions that came with your lead regarding maximum
load while cable is wound. If in doubt, ensure that the entire cable is unwound. Using a coiled
extension lead will generate heat which could melt the lead and cause a fire.
Loading ...
Loading ...
Loading ...