Loading ...
Loading ...
Loading ...
8. PREPARING THE BLOWER VAC
8.4 ON/OFF SWITCH - FIG. 8
- 13 -
To activate the garden blower/vacuum, fully press
and hold the trigger.
To deactivate the garden blower/vacuum, simply
release the trigger.
NOTE: This appliance should be supplied via a
residual current device (RCD) with a tripping current
of not more than 30mA.
8.5 BLOWER/VACUUM FUNCTION -
FIG. 9
- To interchange between the blower/vacuum
functions adjust control lever.
- Lower adjustment control lever in to position
marked for the blower position.
- Raise adjustment control lever into position
marked for the vacuum function.
8.6 VARIABLE SPEED - FIG 10
Rotate the dial to adjust to required wind speed.
NOTE: Mulching action is automatic when in vacuum
mode and can reduce leaf volume by up to 10:1.
When changing from vacuum mode to blower mode,
wait for debris to exit the chute and enter the bag
before switching to prevent debris being blown down
the blower tube or jamming mode selector switch.
When using blower mode, it is important to keep the
chute further from the ground, as air is sucked up the
chute before being blown out through the blower tube.
Allowing the chute to be near the ground could cause
debris to enter the chute and be blown out through
the blower tube or cause the machine to block.
WARNING: Damage and blockages caused by
operating the blower vacuum function control lever
(6) whilst the motor is running are considered
misuse and are not covered by any guarantee.
CAUTION: Avoid sucking up gravel and stones.
These can permanently damage the blowervac
internal components. Any resultant damage is not
covered by the guarantee.
FIG. 8
FIG. 9
FIG. 10
Loading ...
Loading ...
Loading ...