Loading ...
Loading ...
Loading ...
21
Owner’s Manual
CARE & MAINTENANCE (Continued)
Cleaning the Filter Sensor
The Filter Sensor is located on the back,
above the Filter Slot Cover.
1. Open the panel (Sensor Cover).
2. Using a dry cotton swab or small, soft brush,
gently remove any dirt or dust from the Sensor.
3. For more buildup on Sensor, wipe with a slightly
wet cotton swab.
4. Remove any moisture with a dry cotton swab.
• The Filter Sensor requires regular cleaning
(approx. every 3 months) for the unit
to operate efficiently.
• If the OxyPure is set up in an area with high dust accumulation, more
frequent cleaning of the Filter Sensor is needed.
• Do not use the cotton swab on any part or area other than the Filter Sensor.
Cleaning Underneath Top Vent
The Top Vent of the OxyPure can be removed to clean the surface
underneath the Top Vent and the inner vent screen.
To clean the surface underneath and inner vent screen:
1. Turn the OxyPure off and unplug the unit.
2. Lift the Top Vent using the built-in tab.
3. Using a dry or slightly wet paper towel, wipe up any dust or accumulated
particles off surface and inner vent screen.
To clean the inner wall opposite of the fan or to remove an object that has
fallen through the inner vent:
1. After removing Top Vent, locate the two screws
closest to the end on the inner vent near the grill
opening, underneath the main Top Vent. DO NOT
unscrew the four outer screws.
2. Use a Phillips screwdriver to loosen the two
screws (only).
3. Lift up inner vent.
• Only a portion of the inner vent will lift up.
4. After cleaning inner wall with a soft cloth or paper
towel, reassemble inner vent, retightening the
two screws, and replace Top Vent.
• Make sure all parts are secure before plugging
OxyPure back in and turning on again.
Note: DO NOT unscrew the four outer screws located toward the corners.
Doing so will void your warranty.
Sensor Cover
XX XX
XX XX
Loading ...
Loading ...
Loading ...