Loading ...
Loading ...
Loading ...
Abouttheautomaticicemaker.
A newly installed refrigerator may take 12to 24 hours to begin making ice.
Automatic Icemaker
Ondispensermodels,
toaccessice orreach
thepower switch:
o Lift the bin, then pullit
forward until the bin stops.
o Lower the bin to access ice
or reach the power switch.
NOTE:In order to take furl advantage
of the tie-out ice bin, only store items
an the sheff below the ice bin that
are no taller than the lowest point
an the bin.
_ Lift the bin, then pull it
forward until the bin stops.
_ Lift andpuff forward again
to remove the bin.
The icemaker will produce seven cubes
per cycle,---approximately 100-130 cubes
in a 24-hour period, depending on freezer
compartment temperature, room
temperatm'e, number of door openings
and other use conditions.
If the refrigerator is operated befbre the
water connection is made to tile icemake_;
set the power switch in tile O(off}position.
When the refrigerator has been connected
to tile water supply, set tile power switch to
tile I (on) position.
Tile icemaker will fill with water when it
cools to 15°F (-10°C). A newly installed
refiigerator may take 12 to 24 hours to begin
making ice cubes.
You will hear a buzzing sound each time
the icemaker fills with water.
Throw away the first few batches of ice to
allow the water line to clear.
Be sure nothing interferes with tile sweep
of tile fi?eler arm.
When the bin fills to the level of the f_eeler
arm, the icemaker will stop producing
ice. It is normal for several cubes to be
joined together.
If ice is not used frequently, old ice cubes
will become cloudy, taste stole and shrink.
Special note about dispenser models:
_ Dispenser models have a tilt-out ice bin.
The bin can be tilted out as shown in the
illustrations, and it will hold itself up
while you take ice out or turn the
icemaker power switch on and off Be
sure to put the bin back in place before
closing the door.
_ To restore your ice level from an empty
bucket stage, the following steps are
recommended:
I_ 12 hours after the first batch of ice
has fallen into the bin, dispense
3 to 4 cubes.
After an additional 6 hours, dispense
3 to 4 cubes again.
These steps will restore your ice level
in the shortest amount of time.
ilili!!i!ii!iiiii___1
NOTE:Inhomeswithlower@an-averagewater
pressure,youmayheartheicemakercyclemultiple
timeswhenmakingonebatchofice.
Removing Ice Bin (dispenser models)
CAUTION:Theice binis heavywhen full.
Set tile power switch to the 0 (Off)position
before removing tile bin.
Whenreplacingthebin,be sure to press it
firmly into place. If it does not go all tile
way back, remove it and rotate the drive
mechanism 1/4 turn. Then push tile bin
back again.
14
Dispenser Models only
Loading ...
Loading ...
Loading ...