Loading ...
Loading ...
Loading ...
9
1. Fill the kettle using either the spout or lid.
2. The water level must be between the MAX and MIN ll lines.
3. Check that the lid is closed correctly.
4. Ensure that the base unit and the base of your kettle are not wet.
5. Place the kettle onto the base unit and plug in.
6. Switch the kettle on by pushing the On/Off switch to the ‘On’ position.
7. Your kettle will begin to boil and will switch off automatically when it is done. The On/Off
switch will automatically move into the ‘Off’ position when done.
8. The kettle can be switched off manually by putting the On/Off switch to ‘Off’.
9. If you need to boil the kettle again, wait for a few seconds - allow the On/Off switch time
to reset.
10. When you lift the kettle up from the base, you may see drops of water on the base. This
is just condensation from steam.
11. To avoid splashing or spilling, pour the kettle slowly and do not over-tilt it.
Tips: Improve the quality of your drinks by always using fresh water.
Empty the kettle after each use.
Be economical and do not boil more water than you need.
Boil Dry Protection:
• Your kettle will switch off automatically if you try to use it with too little water.
• If this happens, ensure the On/Off switch is in the off position, remove it from the base
unit and allow it to cool down before re-lling.
Washable Filter:
• Your kettle is tted with a lter. The lter helps to prevent lime-scale from getting into
your drink.
• The lter should be cleaned regularly, in particular if there are noticeable deposits left on
it, or if pouring is affected in anyway.
• To clean the lter, remove it from the kettle and rinse it under the tap. You can also drop
the lter in when de-scaling your kettle.
• Rinse the lter thoroughly before tting it back into the kettle.
5 - Using Your Appliance
Loading ...
Loading ...
Loading ...