Loading ...
Loading ...
Loading ...
ReinstaHation of the Doors
1, Install hinge assemblies:
. Install top hinge loosely with %/' hex head
screws.
Install center hinge with Phillips screws.
Freezer door models: Install bottom hinge with
Ys"hex head screws.
2. Freezer door modeJs: Insert bottom
hinge pin.
Locate bottom hinge hole closest to
outside edge of cabinet, and insert
bottom hinge pin. Replace any door
shims, if present.
3, Freezer door models: Place hinge
side of freezer door on bottom hinge
pin and hold freezer door upright
while installing center hinge pin with
-?#' hex head driver.
Replace plastic sleeve.
Replace any applicable door shims.
, Make sure the hinge pin is installed tightly.
4. Place hinge side of refrigerator
door on center hinge pin.
5. While holding refrigerator door
upright, tighten down top hinge
with -Y#' hex head driver and
replace hinge cover.
Door ReversaJ
In some installations, reversing the door swing allows
for more convenient access to stored items. Both
doors can be reversed on freezer door models and the
fresh food door is reversible on freezer drawer models.
1, Remove door(s} (see page/4},
2. Transfer cabinet plugs and cabinet
screws to opposite side of cabinet.
, Remove cabinet plugs with flat
blade of screwdriver tip wrapped
in masking tape.
, Remove center mullion screws
with _/,?' hex head screwdriver.
, Freezer door models: Remove
bottom mullion screws with s%,hex head driver.
3. Transfer door stops from bottom edge of fresh food
door and freezer door, if applicable, to opposite
side of door edge.
Use a Phillips screwdriver
for removal and installation.
4, Install handles (see pages 6,
7 or 8},
5. Reinstall the door(s}.
If not installed, the handle is located in the interior of
the fresh food section or attached to the back of your
refrigerator.
Remove and discard handle packaging and tape.
Handle design varies from refrigerator to refrigerator.
Please reference the appropriate instructions for your
model below.
Fresh Food HandJes
Standard Front Mount NandJe
Materials Needed
. Phillips screwdriver
" %/hex head driver r
To Unstalh
1. Remove K" hex head screws from .
door face with hex head driver, and
Phillips screw from top of door.
If reversing door, remove door
plugs from opposite side of door
and insert in screw holes.
i ,,
2. Align handle holes with screw holes on ! Jl
door face and secure with two door face
screws from step 1.
Loading ...
Loading ...
Loading ...