Loading ...
Loading ...
Loading ...
9
Center Back of Cabinet
Float with retainer clip
(reference)
For normal
operation,
float retainer clip
should be in
bottom section
of middle slot.
Fasten float
retainer clip
into top section
of middle slot
for manual dryout
CONTROL LOCK DEACTIVATION PROCEDURE
To deactivate the “CL” function simply press and hold the power button for 5 seconds.
“CL” will flash at the rate of 1 second on and 1 second off for a period of 2 seconds
and then resume the display of room humidity.
MANUAL DRY OUT
At the end of the
humidification season or if
you do not plan to run the
humidifier for one week or
more, a manual dry out
mechanism is provided to
completely dry out the
humidifier cabinet. To do
this, simply slide the float
retainer clip located at the
back of the humidifier
cabinet to the top of the middle slot,
as it is shown in the illustration. This will
hold the float in an upward position and the fan will run until you turn the power off.
NOTE: Be sure to reposition float retainer to the normal operating position (lowest
portion of the slot) before using the humidifier again. See diagram for proper
placement of the float retainer in the float retainer slot in the cabinet back.
REPLACEMENT OF WICKS
WARNING: To reduce the risk of shock or injury from moving parts, always unplug
humidifier before removing or replacing any parts.
NOTE: This unit uses model HDC12 wicks. Replace the wick at the beginning of each
season, and more often in areas with hard water. The wicks may be rinsed periodically
in clear water only. Take care not to damage paper. To replace evaporative wicks in
your humidifier, follow these instructions.
WICK REPLACEMENT
1. Unplug humidifier before removing the wick. We recommend moving the
humidifier to an area where floor coverings are not susceptible to water
damage, i.e. kitchen or bath areas.
2. Open the pivoting lid andremove water
bottle s and set aside. Grasp the fan
assembly front center and rear center.
Left off and set aside on a clean flat
surface. The wick housings are now
accessible.
3. Lift wick housing out of cabinet and
place where you may work on them
comfortably. With a soft, absorbent
cloth remove any remaining water or
loose mineral deposits not trapped in
the wick from the humidifier cabinet.
Loading ...
Loading ...
Loading ...