Loading ...
Loading ...
Loading ...
• Iflever(q)(figure12)in
baseofhousingbecomes
dislodged,replaceincorrect
positionbeforeinsertingnew
spoolintohousing.
•Removeanydirtandgrass
fromthespoolandhousing.
•Unfastentheendofthe
cuttinglineandguidetheline
intotheeyelet(r)figure13.
•Takethenewspooland
pushitontotheboss(s)
(figure12)inthehousing.
Rotatethespoolslightlyuntilit
isseated.
Thelineshouldprotrude
approximately5-3/8inches
(136mm)fromthehousing.
•Alignthetabsonthespool
capwiththeslots(t)inthe
housing(figure13).
•Pushthecapontothe
housinguntilitsnaps
securelyintoplace.
NOTICE: To avoid tool damage, if the cutting line protrudes
beyond the trimming blade, cut it off so that it just reaches the
blade.
To install bulk line, follow the steps below:
• Unplug toot.
• Remove the empty spool
from the tool as described
in "REPLACING THE
SPOOL".
• Remove any remaining
cutting line from the spool.
• Make a fold at the end of
the cutting line at about 3/4
inch (19mm)(u). Feed the
cutting line into one of the
line anchoring slots (v) as
shown in figure 14.
• Insert the 3/4 inch (19mm)
end of the bulk line into the
hole (w) in the spool
adjacent to the slot as
shown in figure 15.
REWINDING SPOOL FROM BULK LINE
(USE ONLY .065 IN. ROUND DIAMETER LINE) (FIGURES 14, 15, 16)
Bulk line is also available for purchase from your local retailer.
NOTE: Hand wound spools from bulk line are likely to become
tangled more frequently than Black & Decker factory wound
spools. For best results, factory wound spools are
recommended.
Loading ...
Loading ...
Loading ...