Loading ...
Loading ...
Loading ...
Blaze Outdoor Products Instructional Book
Page | 18
Leak Testing
All gas piping and connections must be tested for leaks after installation or service along with before each use.
This includes all valves, pipe connections, joints, lines and every point from the gas source to the
burners.
All leaks must be corrected
immediately. Remember-before exchanging an empty bottle for a new one; make sure all
control valves are in
the “off” position. This can create a low flow of gas through the grill. This would require the tank to be
disconnected from the regulator, and then reconnected to reset the regulator.
Open the valve (shut-off or ‘ON’ LP tank). Test for leaks by applying liquid soap solution to all joints. Bubbles forming
indicate
gas leak.
The following diagram is for informational purposes only. These locations are not the only points to check nor
the only potential areas for a gas leak to be present. Ensure the leak test includes all valves, pipe
connections, joints, lines and every point from the gas source to the burners.
NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.
Loading ...
Loading ...
Loading ...