Loading ...
Loading ...
Loading ...
mNSTALLSEAT
Adjust seat beforetighteningadjustment
knob.
1. Removeadjustmentknoband flat
washersecuringseat to cardboard
packingand set asidefor assemblyof
seat to tractor.
2. Pivotseat upwardand removefrom
the cardboardpacking.Removethe
cardboardpackingand discard.
3. Placeseat on seat panso headof
shoulder bolt is positionedover large
slotted holein pan.
4. Push down on seat to engageshoul-
der bolt in slot and pullseat towards
rear of tractor.
5. Pivotseat and panforwardand as-
sembleadjustmentknoband flat
washerloosely.Do not tighten.
6. Lowerseat into operatingposition and
sit in seat.
7. Slide seat until a comfortableposition
is reachedwhich allowsyou to press
clutch/brakepedal all the way down.
8. Get off seatwithout movingits ad-
justed position.
9. Raiseseat and tighten adjustment
knobsecurely.
Seat
Seat
BoUt
FUatWasher
NOTE: You may now roll or drive your
tractor off the skid. Follow the appropriate
instruction below to remove the tractor
from the skid.
TO ROLLTRACTOR OFF SKiD (See
Operation section for mocation and
function of controms)
1. Press lift lever plunger and raise
attachment lift lever to its highest po-
sition.
2. Release parking brake by depressing
clutch/brake pedal.
3. Place freewheel control in "trans-
mission disengaged" position (See "TO
TRANSPORT" in the Operation section
of this manual).
4. Roll tractor forward off skid.
5. Remove banding holding deflector
shield up against tractor.
TO DRmVE TRACTOR OFF SKID (See
Operation section for mocation and
function of controms)
_WARNmNG: Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
1. Be sure all the above assembly steps
have been completed.
2. Check engine oil level and fill fuel tank
with gasoline.
3. Place freewheel control in "trans-
mission engaged" position. (See "TO
TRANSPORT" in the Operation section
of this manual).
4. Sit on seat in operating position,
depress clutch/brake pedal and set the
parking brake.
5. Place motion control lever in neutral
(N) position.
6. Press lift lever plunger and raise
attachment lift lever to its highest posi-
tion.
7. Start the engine. After engine has
started, move throttle control to idle
position.
8. Release parking brake.
9. Slowly move the motion control lever
forward and slowly drive tractor off
skid.
10. Apply brake to stop tractor, set parking
brake and place motion control lever in
neutral position.
11. Turn ignition key to "STOP" position.
Continue with the instructions that follow.
9
Loading ...
Loading ...
Loading ...