Loading ...
Loading ...
Loading ...
HOW TO USE YOUR PRESSURE
WASHER
if you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.
Pressure Washer Location
Pressure Washer Clearance
WARNtNG
Operate pressure washer ONLY outdoors.
Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
DO NOT operate pressure washer inside any building or
enc!osure, even if doors or windows are open.
The pressure washer must be at least 5 ft. (152 cm)
from structures having combustible walls and/or other
combustible materials. Leave at least 3 ft. (92 cm) all
around pressure washer including overhead, for
adequate cooling, maintenance and servicing.
Place pressure washer in a well ventilated area, which
will allow for removal of deadly exhaust gas. DO NOT
place pressure washer where exhaust gas could
accumulate and enter inside or be drawn into a
potentially occupied building. Ensure exhaust gas is
kept away from any windows, doors, ventilation
intakes or other openings that can allow exhaust gas
to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when
positioning pressure washer.
Typical Pressure
Washer Shown
Exhaust Port
To Start Your Pressure Washer
To start your engine-powered pressure washer for the
first time, follow these instructions step-by-step. This
starting information also applies whenever you start
the engine after you have let the pressure washer sit
idle for at least a day.
1. Place pressure washer near an outside water
source capable of supplying water at a flow rate
greater than 3.3 gallons per minute and no less than
20 PSI at pressure washer end of garden hose.
2. Check that high pressure hose is tightly connected
to spray gun and pump. See "Assembling Your
Pressure Washer" for illustrations.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
* Damage to equipment will result from failure to follow
this instruction.
.
6.
hand.
7.
Squeeze trigger on gun to purge pump system of
air and impurities.
Attach nozzle extension to spray gun. Tighten by
Choose ProjectPro TM nozzle you want to use, pull
back on collar of nozzle extension, insert nozzle
and release collar. Tug on nozzle to make sure it
is securely in place. See "How to Use
ProjectPro TM Nozzle System".
8. Engage trigger lock to spray gun trigger.
Trigger Lock
g.
Move throttle lever to "Fast" position, shown here
as a rabbit.
\
\
Throttle Lever in
"Fast" Position
Loading ...
Loading ...
Loading ...