Loading ...
Loading ...
Loading ...
10.Movechokeleverto"Choke"position.
NOTE:Fora warmengine,besurethechokeleveris
in the"Run"position.
11.Whenstartingengine,positionyourselfas
recommendedbelow.Grasphandleandpullrecoil
starterlightlyuntilyoufeelsomeresistance,then
punbriskly.
/
/ '
s.....
io \<
7
i Jw i
I J I
, \
12. Return recoil starter slowly. DO NOT let rope
"snap back" against starter.
WARNING
When starting engine, pull cord slowly until resistance is
felt and then pull rapidly to avoid kickback.
If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze
trigger on spray gun.
3. When engine starts, slowly move choke lever to
"Run" position, as engine warms. If engine falters,
move choke lever to "Choke" position, then to
"Run" position.
14. If engine fires, but does not continue to run,
squeeze trigger on spray gun to relieve internal
pump pressure. Move choke lever to "Run"
position, and repeat steps 11 through 13.
IMPORTANT: If engine floods, place choke lever in
"Run" position and crank until engine starts.
WARNING
DO NOT touch hot surfaces.
Allow equipment to coo! before touching.
The pressure washer must be at least 5 feet from
structures having combustible walls and/or other
combustible materials.
Keep at least 3 feet of clearance on al! sides of pressure
washer for adequate cooling, maintenance and servicing.
In the State of California a spark arrester is required by law
(Section 4442 of the California Public Resources Code).
Other states may have similar laws. Federal laws apply on
federal lands. If you equip the muffler with a spark attester,
it must be maintained in effective working order.
NOTE: Always keep the throttle lever in the "Fast"
position when operating the pressure washer.
How to Stop Your Pressure Washer
1. Let engine idle for two minutes.
2. Move throttle lever on engine to "Stop" position.
CAUTION
l DO NOT stop engine by moving choke lever to "Choke"
position. Backfire, fire or engine damage could occur.
3. Squeeze trigger on spray gun to relieve
trapped pressure in hose to avoid injury.
NOTE: A small amount of water will squirt out when
_ressure is released.
WARNING
.
Keep high pressure hose connected to pump and spray
gun while system is pressurized.
Squeeze trigger on spray gun to relieve trapped
pressure, every time you stop engine. Engage trigger
lock on spray gun.
Engage trigger lock on spray gun when not in use.
10
Loading ...
Loading ...
Loading ...