Loading ...
Loading ...
Loading ...
15 ― English
OPERATION
WARNING!
Do not allow familiarity with
products to make you careless. Remember
that a careless fraction of a second is
sufcient to inict serious injury.
CAUTION!
Remove battery pack from
unit before checking and lling oil reservoir.
Fill oil reservoir with Bar and Chain Oil before
starting the pole saw. Failure to lubricate the
chain will cause damage to the bar and chain.
WARNING!
Always wear eye
protection with side shields marked to comply
with ANSI Z87.1, along with head protection.
Failure to do so could result in objects being
thrown into your eyes and other possible
serious injuries.
WARNING!
Do not use any
attachments or accessories not
recommended by the manufacturer or retailer
of this product. The use of attachments or
accessories not recommended can result in
serious personal injury.
Before each use, inspect the entire product
for damaged, missing, or loose parts such
as screws, nuts, bolts, caps, etc. Tighten
securely all fasteners and caps and do
not operate this product until all missing or
damaged parts are replaced.
WARNING!
Running the saw dry
or with too little oil will decrease cutting
efciency, shorten product life, and cause
rapid wear to the chain and bar from
overheating! Insufcient oil is evidenced
by smoke or bar discoloration! Adequate
lubrication of the saw chain during cutting
operations is essential to minimize friction
with the guide bar!
NOTE:
Do not use dirty, used or otherwise
contaminated oils. Damage may occur to the
bar or chain. Use a proper funnel with a lter
to prevent debris entering the reservoir and
to avoid splitting and overlling the reservoir.
To ll reservoir:
■ Place the product on a suitable at surface
with oil reservoir cap facing upward.
■ Remove the oil reservoir cap.
■ Carefully pour the bar and chain oil
into the reservoir. We recommend using
environmentally friendly chain oil specially
intended to be used with this product.
■ Wipe off excess oil from around the
reservoir.
NOTE:
It is normal for oil to seep from the
saw when not in use. To prevent seepage,
empty the oil reservoir after each use. When
storing the unit for a long period of time (three
months or longer) be sure the chain is lightly
lubricated; this will prevent rust on the chain
and bar sprocket.
NOTE:
Always dispose of lubricant, used
oil and objects contaminated with them in
accordance with local regulations.
APPLICATIONS
The pole saw is intended for cutting limbs
with a thickness of max. 6.9 in. It must not
be used for cutting other materials, such as
plastic, stone, metal or wood that contains
foreign objects, or materials that are harmful
to health. It must not be used for any
purposes other than those described.
Use only the guide bar and saw chain listed
in the Product Specications of this manual.
To reduce the risk of injury, read the entire
manual before rst operation and to observe
all the instructions therein.
CHAIN OIL SYSTEM
See Figure 12, page iv
Check and ll the oil reservoir when battery is
recharged, or as needed.
Loading ...
Loading ...
Loading ...