Loading ...
Loading ...
Loading ...
Self-cleaning
To Start the Self-Clean Cycle
*We recommend a 2 hour self-clean cycle for light soils,
and a 3 hour cycle for average to heavy soils (to assure
satisfactory results).
To Set the Controls for a Self-Clean Cycle:
1. Be sure the clock shows the correct time of day.
2. Push the CLEAN pad. "- - -" appears in the display.
3. Push the UP ARROW pad until "3:00" appears in the
display for a 3 hour cycle, or push the DOWN ARROW
pad until "2:00" appears in the display for a 2 hour
cycle.
4. As soon as the UP or DOWN ARROW pad is released,
"CLn" appears in the display.
5. As soon as the controls are set, the motor driven
lock will begin to dose automatically and the "Door
Locked" indicator light will flash. DO NOT open the
door while the light is flashing (it takes about 15
seconds for the lock to close).
6. The "Door Locked" light will glow until the cleaning
cycle is completed or cancelled, and the oven
temperature has cooled.
When the Self=Clean Cycle is Completed:
1. The time of day will appear in the display window
and the "Door Locked" light will continue to glow.
2. Once the oven has cooled down for about 1 hour and
the "Door Locked" light has gone out, the oven door
can be opened.
Stopping or Interrupting a Self=Cleaning Cycle
If it becomes necessary to stop or interrupt a self=
cleaning cycle due to excessive smoke or fire:
1. Push the CLEAR OFF pad.
2. Once the oven has cooled down for about 1 hour and
the "Door Locked" light has gone out, the oven door
can be opened.
3. Correct the condition which caused the smoking.
4. Restart the self-clean cycle once all conditions have
been corrected.
Use care when opening the oven door after seIFclean-
ing cycle. Stand to the side of the oven when opening
door to allow hot air or steam to escape.
DO NOT force the oven door open. This can damage
the automatic door locking system. Use caution when
opening the door after the self-cleaning cycle is com-
)leted. The oven may still be VERY HOT.
ii
Failure Hodes
All failure modes give a visual and audible alarm. When
display shows 1:10 (temperature runaway), 1:30 (oven
sensor circuit fault) or 1:90 (motor door lock fault), the
electronic oven control has detected a fault condition.
Note that code and push the CLEAR O1:1:pad to clean
the display and stop the beeping. Reprogram the oven.
[f fault recurs, push CLEAR O1:1:pad, disconnect the
appliance to prevent damage and contact an authorized
servicer.
Loading ...
Loading ...
Loading ...